Re: D4D not working

Conor Farrell
 

Does the TX light go on? If it does, check the solder joints for the three coils. If there is enamel still on the ends of their wires, they may not form a proper connection.

I had this problem recently. I simply reheated the solder joints and waited until the enamel melted off and burned away. This solved the issue for me.

Conor

On Tue, 15 Oct 2019, 18:41 Dr. Pedro E. Colla (LU7DID), <lu7did@...> wrote:
RX apparently fixed, C2/C3 were the corresponding to 40m therefore the oscillator didn't started.

Now going after the TX part which isn't working.

73 de Pedro, LU7DID

Join crkits@groups.io to automatically receive all group messages.