Hello Andrew, I am looking over the website you recommended. I understand you like the MM-BSM-9 version which has the Shure clips to fix to your clothing. Have you tried the MM-BSM-8? these are

Hello Mike, Andrew sent me a sendspace link to a copy of a Blind Cool Tech podcast. Find that and you will have a comprehensive review. In short, no it doesn’t have any accessibility features. Now

Hello everyone, I have been noticing a lot of discussion about the Zoom H6, so I know that it can be used by blind people. Does anyone know of a podcast which specifically discusses the level of

Hello Frank, The problem with the cloud lifter is that you need 2 cables. Where as the Fethead is in line. Fethead also have a version that passes fantom on to the mic should you need gain on a

I have the H6, do not yet have an NT1A but by all accounts it is one of the quietest mics on the market. I do not recall the exact specs but the head room on the H6 preamps is much less than that on

Good point. The lifter uses phantom power but it does not get through to the mic. So its mostly for ribbons and dynamics. Frank

A small box with XLR in and out connectors and no other switches or connectors. It's a mic preamp designed to lift the signal of low output mics out of the noise floor. Without looking it up I am

Hello John, I take him seriously. He is a professional voice actor. Furthermore what bothers me about this thread is that it is rather subjective. We al may be born with the same hearing but as we

I see. I hope they are quiet! Hard to tell over youtube. Georgina Joyce wrote: -- Your life is like a penny. You're going to lose it. The question is: How do you spend it? John Covici

Hello John, Nice to see your name and signature again. Take a look at this video. https://www.youtube.com/watch?v=VlCIZ60NCfk Gena Call: M0EBP DMR ID: 2346259 Loc: IO83PS 73

OK, what is a cloud lifter? Georgina Joyce wrote: -- Your life is like a penny. You're going to lose it. The question is: How do you spend it? John Covici wb2una

Hello, Providing we are talking about XLR connected mics and have access to fantom power. Don’t forget the fethead an alternative to the cloud lifter. They also do one for condenser

Frank what have you found? Do you have an NT1-A? Is the H6 noisy with it? As I explained to Gena Neal does the NT1-A tests in his computer room so you have his batteries eating into the floor noise.

There are several ways to reduce noise. You can start with the NT1A, you can switch from the H6 to the F8N which has a lot more noise free gain or you can stick with a mic of your choice and the H6

Andy found Dane's email. Message me off list because I don't know if he'll want the whole list to have it or not. He use to be on this here list.

Hello Hamit, Oh I see. I might listen out to understand what is achieved by such arrangements. I listened to a couple of reviews of the Rode NT-FS1 and I just don’t get it. I listened hard to hear

Hi Gena. The KM 140s were condencers from Newman. I say were because it looks like they are gone. They were $15 thousand each 1. So what neal did with them is put them on a stereo bar that is set up

Hello Hamit, You’ll have to explain 2 KM140s in ORTF. Regards, Gena Call: M0EBP DMR ID: 2346259 Loc: IO83PS 73

He's in Madison Wisconsin. He's a musician and naturest to an extent. He loves recording birds lakes tranes all kinds of things. He uses 2 KM140s in ORTF.

Hello Andy, Pixy mount is a stand, tripod I think. The Deadcat you mean the wind jammer? Is this for the clip on mics? My block of foam that came with it is still wrapped. Regards, Gena Gena Call: