Re: Help Needed for Behringer Audio Mixer x1622 USB & Recording With Goldwave


Philip Francis Anderson
 

Hello Georgina

Yes, it's connected via XLR and the gain is set. I'm hearing everything just fine in my headphones. I have four individual mike channels to choose from and I have tried each one in turn.

I'll let you know should I have any joy.

Thank you once again for your suggestions.
Cordially
Philip
Philip Francis Anderson
Independence for life! Making a Difference, Making it Happen!
Winner of "Let's Do Enterprise North Staffordshire 2007.

"Laborate pro sapientia et salute" - Let us work for wisdom and health.

Contact:
Lan: 01782 970755
Mob: 07948 568191
E: pfa@philip-anderson.co.uk

Available for media interviews and after-dinner speeches.

Confidentiality:
The content of this email is intended for the recipient specified in this message only and maybe legally privileged. It is strictly forbidden to share any part of this message with any third party without the written consent of the sender.
If you received this message in error, please reply to pfa@philip-anderson.co.uk and follow with its deletion, so that I can prevent a similar mistake from occurring in the future.
Thank you for your cooperation.

Consider The Environment. Do not print this email and it's associated content unless it is absolutely necessary.
The recipient should check this email and any attachments for the presence of viruses. While every effort to safeguard this message from viruses has been taken, no liability is accepted for any damage caused by any virus transmitted by this email.

-----Original Message-----
From: all-audio@groups.io <all-audio@groups.io> On Behalf Of Georgina Joyce
Sent: 24 August 2020 00:51
To: all-audio@groups.io
Subject: Re: [all-audio] Help Needed for Behringer Audio Mixer x1622 USB & Recording With Goldwave

Hello Philip,

I guess you know far more than I. However, I will suggest. The microphone? Are you feeding it fantom if it is needed? Is it a nice quiet NB-7B? If it is one of those combo XLR / 1/4 jack sockets there may be a gain switch. You should be able to get it's manual online. The Behringer I had the manual was available.

Good luck,

Gena

On 24 Aug 2020, at 00:08, Philip Francis Anderson <pfa@philip-anderson.co.uk> wrote:

Thank you, Georgina. I know the button you are talking about. Yes,
it's depressed. Upon running a test, it is saying my microphone levels
within Goldwave are too low. However, even when I increase them to
maximum, playback still returns silence. This said, when I switch from
USB Audio Codek within GW's Device Tab to USB Codek Looped back
Speakers, Goldwave will allow me to record and playback sounds captured via my computer.

It is possible there's another button on the Behringer which I need to
activate, or another setting within GW I've overlooked.

Thing is, I'm knew to this particular brand of mixer. I use to own
quite a snazzy Alan Heath Mixer in the past, but the one I wanted and
was familiar with, was just a tad outside my current budget. Had I
still been working in radio, then I could have justified the £1,000
capital outlay. It just so happened I managed to purchase this
Behringer XENYX 12 channel X1622 USB for under £200.00 brand new from
Bax Music. Quite a bargain I thought, till this problem with the
microphone occurred. I'm sure I'll conquer the little beast in time. Just a matter of patience.

Cordially
Philip
Philip Francis Anderson
Independence for life! Making a Difference, Making it Happen!
Winner of "Let's Do Enterprise North Staffordshire 2007.

"Laborate pro sapientia et salute" - Let us work for wisdom and health.

Contact:
Lan: 01782 970755
Mob: 07948 568191
E: pfa@philip-anderson.co.uk

Available for media interviews and after-dinner speeches.

Confidentiality:
The content of this email is intended for the recipient specified in
this message only and maybe legally privileged. It is strictly
forbidden to share any part of this message with any third party
without the written consent of the sender.
If you received this message in error, please reply to
pfa@philip-anderson.co.uk and follow with its deletion, so that I can
prevent a similar mistake from occurring in the future.
Thank you for your cooperation.

Consider The Environment. Do not print this email and it's associated
content unless it is absolutely necessary.
The recipient should check this email and any attachments for the
presence of viruses. While every effort to safeguard this message from
viruses has been taken, no liability is accepted for any damage caused
by any virus transmitted by this email.

-----Original Message-----
From: all-audio@groups.io <all-audio@groups.io> On Behalf Of Georgina
Joyce
Sent: 23 August 2020 23:20
To: all-audio@groups.io
Subject: Re: [all-audio] Help Needed for Behringer Audio Mixer x1622
USB & Recording With Goldwave

Hello,

I don't know that mixer but it sounds like an audio routing problem.
You clearly have the USB part of the mixer installed and now the
microphone output needs to be routed to the master track. I know how
this would be done in Reaper but I have not used Gold Wave. I suspect
that the mixer only uses one channel to Windows. Therefore, there must
be a switch on the console to route the microphone's output to USB.

Regards,

On 22 Aug 2020, at 17:17, Philip Francis Anderson
<pfa@philip-anderson.co.uk> wrote:

Hello All



I'm new to this list and wondered whether anyone is currently using a
Behringer x1622 USB 12 channel mixer in conjunction with Goldwave on
Windows
10 with NVDA?



My problem? Goldwave is not capturing sound via my microphone
connected to my Behringer.



The hardware is working since I am able to hear my voice through my
headphones while speaking.

I am also able to playback sound files in Goldwave through my
Behringer mixer.



Volume levels in both goldwave and windows are set to maximum until I
can achieve a result.



Under "Device Tab" in Goldwave, playback and record are both
utilising USB Audio Codek, the sound driver recommended for my Behringer.

Under Microphone, the quality is set to 44100hz /32 / shared.



In windows privacy settings, both Goldwave and microphone are enabled
with assigned permissions respectively.



If anyone has any solutions, please share.



Thank you in anticipation.



Cordially

Philip

Philip Francis Anderson

Independence for life! Making a Difference, Making it Happen!

Winner of "Let's Do Enterprise North Staffordshire 2007.



"Laborate pro sapientia et salute" - Let us work for wisdom and health.



Contact:

Lan: 01782 970755

Mob: 07948 568191

E: pfa@philip-anderson.co.uk



Available for media interviews and after-dinner speeches.



Confidentiality:

The content of this email is intended for the recipient specified in
this message only and maybe legally privileged. It is strictly
forbidden to share any part of this message with any third party
without the written consent of the sender.

If you received this message in error, please reply to
pfa@philip-anderson.co.uk and follow with its deletion, so that I can
prevent a similar mistake from occurring in the future.

Thank you for your cooperation.



Consider The Environment. Do not print this email and it's associated
content unless it is absolutely necessary.

The recipient should check this email and any attachments for the
presence of viruses. While every effort to safeguard this message
from viruses has been taken, no liability is accepted for any damage
caused by any virus transmitted by this email.





Georgina


Call: M0EBP
DMR ID: 2346259
Allstar: 52178
Locater: IO83PS







Georgina


Call: M0EBP
DMR ID: 2346259
Allstar: 52178
Locater: IO83PS

Join all-audio@groups.io to automatically receive all group messages.