I have recently updated SDR# to version 1.0.0.1732, and encountered a weird bug. If the Frequency correction is set to a fractional value when using HackRF One, it is multiplied by 10 on next start of

#sdrsharp

Prog, Thanks for the reply, I didn't know that, will reset it. Jos Op 30-10-2019 om 16:33 schreef prog: Virusvrij. www.avg.com

#sdrsharp

This is a known syndrome.

#sdrsharp

I was in contact with author: Василий Беляков in Latin Vasiliy Belyakov <belvasi@yandex.ru> and he is willing to modify the dsd_tcp plugin, but I will quote him "Plugin and DSDPlus communications use

#sdrsharp #plugin #dsdplus #tcp

Cheap.

#sdrsharp

Thanks for the info. Installer updated with missing dll. Same link. Regards

#software #sdrsharp

#sdrsharp #airspyhfplus #airspydiscovery

Aah, poering the LNB, that's what I missed, thank you, I'll look into the voltage inserted.

#hardware #sdrsharp

No and abso-damn-lutely no. {^_^}

#hardware #spyserver #sdrsharp #gnuradio #airspydiscovery

Thanks Bjaerne. Will have a look then. Thanks for your interesting tweets. Always appreciated. Missing to go to Norway.... 73

#sdrsharp

Hi Youssef, About my suggestion to jump the VFO in order to see the spectrum above or below the current chunk, I did not noticed that clicking on the VFO strip near any end the program does these jump

#sdrsharp

That works fine until you try to click on a frequency along the spectrum then it will jump to the exact frequency you point at rather than the closest 'step' if you had snap to grid checked. It's real

#sdrsharp

I'm tried to run SDR# on linux(Mint 19.2 x64 bit), by Wine and Mono. Old version(which is on the Github) runs ok on Mono, but it date is 2015 and it hasnt much functions. Latest version starts GUI on

#sdrsharp

Ok so accidentally I seem to have found the issue. It seems to be with the standard RTL-SDR .dll that comes from the included install.bat, When its selected in the source selection section of SDR# the

#sdrsharp #RTL

In the works now: The total gain API with 1 dB resolution. It should work regardless of the gain mode (AGC or Manual). Given the MDS curve, one can make a high dynamic range spectrum analyzer with a d

#sdrsharp

Hi Mitja, I wish you would use Linrad instead. That would force you to take decisions yourself. Could be difficult, but probably rewarding. The Airspy r2 uses an R820T (or R820T2) tuner. The tuner has

#sdrsharp

Is this in terms of noise in the demodulated FM or in terms of the spectrum display? If it is the spectrum display it's a simple matter of bandwidth. I tend to run at 262144 bins for the FFT. On an R2

#sdrsharp

Hi All, You can use the signal evaluation tool in SDR#. Set a bandwidth of your choice and connect a dummy load to the antenna input. The noise figure of the HF+ discovery is known, something like 5 d

#sdrsharp

I want to change the fftOffset in a SDR# running as client in my LAN, but doesn't work.

#spyserver #sdrsharp

You can do it in a plugin by hooking the MPX stream and doing the demod. You can also output the recovered audio in a separate audio device (reuse the audio infrastructure in the SDR# framework).

#sdrsharp