Thank you both. I went back to the "old" way of installing plugins and have Scytale up and running, though I notice that when I run it outside of SDR#, there are some features that I find useful. I al

#software #sdrsharp

Where can I find the plugins for latest version of SDR# without installing Community package? I don't see them available for download from the Airspy website. I would prefer to install them individual

#software #sdrsharp

I'm fully aware that things that are grayed out indicate they are inaccessible, but since the input in the last version I used (1762) was set at 192,000 as opposed to 48000 in the new version, I was w

I just installed version 1781 and it detects my Airspy R2 with no problem. When I go to the audio setting panel, it will not let me set the sample rate or the input source. It does permit me to change

I found some 1 inch PVC plumbing parts while cleaning out the basement and made a simple frame/base for my YouLoop to make it easier to keep its shape and to have a support for it no matter where I'm

#youloop

OK, I knew that. I thought you were suggesting that it had something else to do with the total deafness of the unit. I'm 99.9% sure the cause is the connector. I'll probably have to gather my courage

jdow - on Sept 26 you asked if Shift tickkbox was checked. I replied I tried it both ticked and unticked and it didn't make a difference. Just for my own knowledge, can you explain what effect that wo

I received the same email yesterday claiming to be in response to my recent posts about my Spyverter problem. I immediately thought the wording and a reference to a form I supposedly requested was odd

#offtopic

Everyone's input has been very helpful. I haven't had time to check the connector beyond determining that the center pin has not detached from the circuit board. I'm betting that the problem is the on

I got 5.1 volts with it directly connected to the USB port and 4.61 when connected thru the Airspy via the barrel connector. According to the specs that should be sufficient.and shows that both power

The antenna is a PAR EF-SWL. It is up and secure. It works fine with my Funcube, so I don't think that is the problem.

I unchecked the Shift box and it made absolutely no difference.

The connectors appear to be fine- no holes beside the inner socket. When using the Spyverter, I either connect it with the barrel connector that came with it or a separate SMA interconnect cable. Is t

I'm wondering if there's any connection between my earlier problem of the Spyverter's being way off (30Khz) in calibration?

I've connected/disconnected a few times, but am careful to connect in the correct direction. Yes, I do see a massive birdy on 120Hhz. The R2 is working well by itself.

Dave, My Spyverter.does not have any indicator LEDs.

My Spyverter installation has suddenly become deaf. Here's what I did so far: 1.Checked the connection between the Airpsy R2 and the Spyverter. (The Airspy runs fine on its own.) 2. Opened the Spyvert

I need to replace the male SMA connectors on the feedline of my YouLoop. I see lots of connector sizes based on the size of the coax. What size is the one on the YouLoop?

Don't have that cable :-(

For as long as I have been using SDR# - back to version 1400 something, original or community edition, the only way they run is when I use administrator permission. If I try to start the program witho