I see this is a beaglebone board. Just FYI, this board was never tested with the SpyServer. Make sure airspy_rx displays the right sample rate figures and try updating the firmware is necessary: https

#spyserver

Updated firmware. airspy_rx appears to show correct sample rate, etc but same issue on spyserver. I'll switch back to the RasPI 3 and try it again there. May just not like BBB or something.

#spyserver

Did you try with the default spyserver.config file without modifications?

#spyserver

Yes. Same results. Tried with a combination of changes from none to complete in the config file. Also killed firewall on both sides+@ internal router - running default DD-WRT config for now - disabled

#spyserver

Hi All, Just revisited Spyserver after a break of several months - wow what a difference - well done :-) One question - I'm trying it with a RTL SDR V3 dongle and serving it to SDR# however notice tha

#spyserver

A few enhancements: Better IQ quality on 8bit mode, Added a new FFT resolution setting. Adjust to the CPU of your machine. Download as usual from: http://airspy.com/download/ Check the detailed change

#spyserver

Missing the 64-bit version ? :( Tormod LA4ELA

#spyserver

Hi, few months im running Spyserver on sdr://193.93.75.99:5555. HW RPi3, RTL-SDR V2 (planed Airspy Mini, after exchange my "home" dongle with HF+), 144-146MHz band, double helix as sharp preselector +

#sdrsharp #spyserver

The FFT FPS is set a bit too low, but the IQ stream is very good. Did you test your RPi3 with 6 concurrent sessions?

#sdrsharp #spyserver

Yes, with 6 concurrent sessions is CPU load at 80% and audio is smoth even tuning. FPS is low because CPU load, at 15FPS is only 3 concurrent sessions possible. At 1FPS are 8 concurrent sessions possi

#sdrsharp #spyserver

You can now also reduce the fft_bin_bits to a lower value. The default is 16 (64k FFT). I just redeployed a config file with the right setting name. Same execuables.

#sdrsharp #spyserver

fft_bin_bits i set to 8 yesterday :)

#sdrsharp #spyserver

Are you sure you didn't set fft_bins_bits instead? Just fixed.

#sdrsharp #spyserver

Ok, just updated to v2.0.1618 and config compared and corrected (fft_bin_bits). Actual settings down on the web page: https://sites.google.com/site/om1aeg/websdr

#sdrsharp #spyserver

Now you should be able to add more session with fft_bin_bits = 15.

#sdrsharp #spyserver

I can't seem to find this information, my apologies if I have overlooked it (especially if it is in an obvious place). Port forward rule for my router allows ALL, TCP or UDP. Which does Spyserver use?

#spyserver

It would take you less time to test than to write this email. SpyServer uses TCP as of today.

#spyserver

Yea but then I couldn’t get a ‘cheerful’ note from you... Thanks for the response. Sent from my iPhone

#spyserver

Jokes aside, TCP solves many problems when it comes to connecting people over the Internet. So far it has proven to work fine even with extreme latency. We have tested different setups between Austral

#spyserver

Ha! UPnP, funny. Sent from my iPhone

#spyserver