Hi, I try to run the latest version of SpyServer on Raspberry Pi 3 with Raspbian, but get the following error: Raspi runs quite fresh raspbian (Linux raspberrypi 4.9.41-v7+ #1023 SMP Tue Aug 8

Blame the Germans, they started our language. Simon Brown, G4ELI www.dxgalaxy.com www.sdr-radio.com www.sdr-satellites.com

Hi All, There is a squelch in Linrad that is based on an FFT analysis of the baseband. It works in all modes, AM, FM, SSB and CW. It would open the squelch at very low levels and the user can set a

So is the coffee through the nose when you realize this is RSGB's doing from the natural home of the English Language. {^_-}

Typo or spelling mistake? Most of my students don't know how to spell "receiver" correctly! :-( -- (Prof.) Richard

nice, i hope you will have some time soon. Looking forward to it!

thank you for the quick reply i can not understand why ettus behave like that, i think they should be thankful if sdr# supports it.

The typo is free!

When we have some time.

Just forget about it. We are not going to pay Ettus on top of supporting their hardware for free.

Will SDR-14 be supported by SDR sharp in the future? Would be great!

i use very old version of sdr# with usrp but i like to use the actual version with usrp, because zadig dll support only freq. to 2,1 GHz so can i have a copy of this dll, too? gqrx is not a real

several sdr software have such a funtion (simon also added it in sdrconsole v3) i was wondering why not all commercial radios have such a function for adding such a thingy to your "normal" rig you

Syllabic squelch is the only good HF squelch. I think it has been patented by some firms. Icom's old version of VSC used to be quite similar, but their DSP version of it in later radios didn't work

fyi, I tried so many combinations on rx_fm but audio from fm stations were extremely slow. Using GQRX, audio was fine and smooth. I was planning on using use rx_fm to record NOAA APT similar to what I

Problem was my vm. It works fine on mac and odroid.

The Airspy mini arrived today. It works with GQRX. I'm trying the rx_fm but looks like SoapySDR cannot detect it. I'm not sure if I missed anything. I followed the build instructions from their

I fixed it after doing this https://github.com/pothosware/SoapyAirspy/wiki#building-soapy-airspy :)

My Airspy Mini arrived today. I'm testing it with GQRX where I was using an rtlsdr dongle. I tried NOAA Radio at 162.5MHz but I was wondering why it sounded like Donald Duck. Any

The block diagrams I've seen from Youssef et al show a 16 sampler block diagram. At least a couple are show labeled 1 and 2 and maybe 3. Then the last one is labeled 16 and has an elipsis above it