Hello all- At http://sdr-radio.com/AirspyHFPlus With regard to the NDB band comparision- when I click on the two 'thumbnails' to pull up more detailed screenshots, the HF+ screenshot is taken at

Hi everyone, my 1st post, quick intro, i've been scanning for 30+ years, SDR"ing" for the last 3 years, with several nooelec dongles including v3. I jumped in the Airspy / spyverter wagon couple

Hi Ruben, A more easier (and safer) way to change the audio sample rate is: - In the Source Tab, select a radio that is Sound Card based, i.e. "Softrock (Si570)" or "IQ from Sound

In meantime.... Play with Spyserver! https://www.youtube.com/watch?v=lxT4_uJcdpc Remote station build with a OrangePIZero, OS Software Armbian, Spyserver and NeoRouter-Mesh for the VPN. Internet is

Thank's a lot. I will try it.

You can force a different sample rate by editing the SDRSharp.exe CONFIG file. That file is an ASCII text file that you can modify with a text editor like Notepad and contains two vales related to

You are most likely confusing the "dBm" scale with the actual noise floor (Check the MDS in the spec sheet). There are only two things to check in these screenshots: * SNR => A slight advantage for

Thank you Simon, nice comparison. Sure HF+ my next sdr. Inviato da OldPhone

Ahhh... I didn't see there were multiples. The first one (VLF). The others are more of a trade-off. 10 dB lower noise floor and signal. Still, quite a respectable performance against a unit that

Do you try fresh install to new place?

I'm guessing you refer to the VLF non-directional beacon plots. Remember, its not about absolute levels but (S+N)/N ratios. Dave - WØLEV -- Dave - WØLEV Just Let Darwin Work

Which comparison? Simon Brown, G4ELI www.sdr-radio.com

Correct me if I'm wrong, but that looks like 10 dB lower noise floor AND 10 dB more signal. (a 20 dB overall gain in range) Joe M.

So, Done properly (or at least better) this time: http://sdr-radio.com/AirspyHFPlus Simon Brown, G4ELI www.sdr-radio.com

I will never trust an active splitter again.

Ah, The measurements are all wrong. Am writing a new blog post, will post here when ready. Start saving for the HF+ 😊 . Simon Brown, G4ELI www.sdr-radio.com

I understand. Tnx a lot.

Yes, I did when I first received it and added support. From memory the HF+ has better MDS & Dynamic Range, I could bring it into the radio room/office but it’s usually in use remotely by a

If something is grayed, it means it's not applicable to your context. You are not streaming from a sound card.

Hello: Using last 32 bits SDR#. Why can't i change samplerate? Always fixed to 48000. Thank's a lot.