Hope to work you on the birds. Brad KC9UQR Sent from Brad's iPod

Also, I'd add to that, PO-101. It's one of the newest satellites out there, but it only operates according to a schedule. Generally, it's Friday and Sunday for the

Thank You all for the replies and updated information- will get to work on them. 73 Paul w2eck

Yes! ‘91 always in same mode ... ‘92 switches to a 1.2gHz uplink for about a day a week. And good ole SO-50 - although a little finicky to get in to - is there, too! And, of course, the ISS’

In my humble opinion, the easiest to work are AO-91 and AO-92 on weekdays or in the evening. Next would be SO-50, same times. Brad KC9UQR

Haven't worked and amateur satellites in a few years. Thinking about getting back into. Can some give me a list or a link to the best ones to help shake off the rust with these days ? 73 Paul w2eck

Hi , I have done few qsos with a ft8800 working ao91 ao92 . Just programme the right frequencies with 5khz gap to easily compensate doppler effect, as you would with a HT. You can do without and

March 07, 2020 RELEASE 20-023 SpaceX Dragon Heads to Space Station with NASA Science, Cargo A SpaceX Dragon cargo spacecraft launches on a Falcon 9 rocket from Space Launch Complex 40 at Cape

From ARISS ... The spouse of ARISS Hardware team member Ed Krome, K9EK, pointed out that the ARISS next generation radio system (InterOperable Radio System--IORS) is prominently described as a primary

Greetings! I don't have a full duplex HT but I do have a Yaesu FT-8800R which does have full-duplex operation when one side is on VHF and the other is on UHF. I wondered if anyone could point me to

What questions do you have?!?

We have a complete ground station and we need some help with putting it into operation. Our basic setup is: M squared LEO pak uhf and vhf antennas Yaesu G-5500 az-el rotator and controller ERC rotator

The files that I sent are for setting up a Kenwood TH-D72A with RT Systems software for satellites. Brad KC9UQR

Hi Jerry: Here are the two files that you need again. I do have a PC. See attached. 73 Brad KC9UQR

Hi Brad, Not sure if you sent me the file, but try again. It may only for a PC system, but I think I may have and old PC that might be able to open it. Jerry...W8RQM

I too have the Kenwood TH D-72A and love it. It is a breeze to set up with RT Systems and a breeze to use. I should be able to send you the RT Systems file and all you have to do is change the call in

@Stephen, I have the Kenwood Th-D72A. Works great. Duplex receive. Jerry...W8RQM

At this point, SatPC32 only supports certain radios, primarily the bigger fixed units that allow for computer control via CAT/CI-V commands. I am not aware of any HTs that could do that and even then,

With an HT, many are successful by just “accommodating “ for Doppler with a step above/below the 440-band frequencies. None required, really, on the 2m side. SO ... either VFO mode for 440 - or

Is there any way to connect something like SatPC32 to the Kenwood TH-D74 to automatically adjust frequencies for Doppler shift? If not, are there any HTs or Mobiles that can do this? Or do you have