Date
1 - 3 of 3
Kuhne MKU 10G3 settings
|
g4bao
Before I tackle Kuhne about this, (as I fear it's another firmware bug!!) does anyone out there know how to make the sequencer delays and frequencies (sent to the new G5 10GHz transverter via the serial port or Kuhne Suite) "stick" ? They seem to revert back to the factory defaults when you power cycle the transverter, unless I'm missing a serial command, link setting or other trick. I do hope that these defaulting 50ms sequencer delays was not the cause of my blown preamp or I might get cross.....! 73 John |
|
|
|
g4bao
The title to this should of course have been Kuhne MKU 10G5 settings!! On Thu, 2 Feb 2023, 16:13 g4bao, <john@...> wrote:
|
|
|
|
Eddy, ON7UN
Hi John,
toggle quoted message
Show quoted text
I recently upgraded the MKU10G5 to V1.02 firmware. To change the 4 different possible sequence delays : Example to 80 mS 80D1 (answer A) 80D2 (answer A) 80D3 (answer A) 80D4 (answer A) After power cycling and command S you see all parameters, the sequence delay has changed from 50 to 80 ms I am also using the KU EDPU external display unit. I can change the SEQ parameters, power cycle and all is stored ( without any “ safe “ command ) If you like I can send you some screen shots. I am using Tera Term as serial connection to the transverter. Vy 73’s Eddy ON7UN
|
|
|