Good news Adrian. Well done on moving so swiftly to make alternative arrangements. Looking forward to being able to hear KBQ again as reception of SCX is only occasional over here.

David the dish I have is the Gibertini OP125 sorry it isn't on that sheet I posted up..

David I have got a 1.25m Gibertini that although very well built is just a bit too unmanageable for the mast I was going to use.

Very many thanks to OZ1FF/Kjeld who sent me the three missing sounds & I installed them very easily. Bit of a mystery why the sounds & username just disappeared. So all working now.

Very strange I am getting this barrier as well. Not that I consummated any QSOs, but I wanted to see how others did. I notice the address is part of the RSGB, but even to view RSGB contests there is n

Ok Andy thanks for the quick reply. Yes I had seen that rather dire warning about the the keys. But presumably my key is still active because I was using KST this morning that was working fine other t

KST2me has been working fine for several years. But today for no obvioius reason, my callsign, chat password & key were not recognised. After entering callsign & chat password, magically my 'key' (wha

No takers, going home now.

Just had a successfull test of the new rig with GW3TKH/P. Anyone else want 24GHz? I'll be here for another half hour but it is a bit cold. Going to KST now

The failure of the Kuhne MKU LO PLL2 to oscillate & give continuous output without having to blip pin 9 to earth, has been a most confusing, exhausting & time wasting exercise with me tangling with pr

Mark yes please send me a picture when you can. I don't need it too compact I need an inch or so on one end. When I used to restore military vehicles I had oxy-acetylene available & silver solder was

Looking for WG20 90 degree E plane bend to complete my robust all-weather home/portable 24GHz rig. There are a few on ebay but they are all overseas, which means the carriage & import charges exceed t

I've still not found a reliable momentary trigger which seems a strange feature. "PIN 9 is a switch input. The input signal to this pin activates or deactivates the main output and the auxiliary outpu

On Sun, Dec 25, 2022 at 09:25 PM, Andy G4JNT wrote: Capacitor to ground on it with possible pull up R - check its sink current. Got a small electrolytic works a treat thanks & now just playing with R

A step forwards! Although on the previous set up two years ago, I never needed to tangle with Pin 9 "The input signal to this pin must be switched to ground ." When I do this momentarily it triggers t

I've sneaked out to the barn & removed the PuTTY lead & put in the four links to give me 11952 MHz, but I can detect no output on a Narda power meter even on 1mW FSD. When I add 10MHz lock at least th

On Sun, Dec 25, 2022 at 01:02 PM, Steve G4HTZ wrote: I just jumped the required pins on mu KUHNE LO to set required frequency ….presumably your trying to use it on a more obscure LO ?? Steve good poin

On Sun, Dec 25, 2022 at 11:44 AM, Andy G4JNT wrote: Nonsense, best day to be in the shack working on fun stuff. Leave the belated solstice stuff to those who want to do it. There only two of us here &

Thanks all for input, but got a sort of feeling today is day for being housebound & not for sliding off to the shack :(

On Sat, Dec 24, 2022 at 07:54 PM, Andy MM0FMF wrote: "Configuration and the state of the oscillator unit can be read out and controlled with the built-in serial interface. Interface configuration: 3.3