Came across this lot on ebay, whilst looking for some other bits, I know nothing about waveguide beyond my level. But thought link might be some use,

In Marconi I remember we banned rightangle SMAs for anywhere near X-Band. Not just due to poor match , but because of their potential to overmode or breakdown The only exception was some very

If you mean RG401 or UT250, the 0.25 inch version of semi-rigid, I have bought it (and the hand-formable version) at reasonable prices at rallies (mainly in Europe rather than the UK

Hi all, Excuse the bandwidth, but I've just uploaded a set of notes to my PAT page on using a PAT to fed an SDR as a 2nd independent receiver with the HF/50MHz band coverage. Given the Rx

During my employed years , in the microwave industry , we would never use 90 degree angled connectors ., as , you will be aware , microwaves , do not like going round corners ........... full stop

Gm all ! F1SRC, F5LWX and F9OE will be /P IN77WT fm saturday 29 1400 TU to 30 1500 TU on 6 and 3 cm. CW and SSB. See ON4KST ! 73 and dx !

I have just dismantled a piece of equipment which I presume was part of a radar system. It has a Marconi isolator Type F1096-22 marked at 9.05Ghz It had 2 right angle SMAs and a tee. The tees

I have just taken dismantled a piece of ex Tornado avionics designed for 8 -18 GHz and there are no right angle SMA bits to be seen. All connections use normal SMA connectors and then semi-rigid coax

Hello Andy The performance of right-angle plugs at 10GHz is a bit of a lottery. I've looked at quite a few cables fitted with them on the incredibly ancient (but still very useful) HP8410 VNA I use

That's a wonderfully useful set of measurements - tnx for posting it Perhaps they could be persuaded to let it appear in Scatterpoint ...??? Anyway, it looks as if my suspicions were correct about

I remember somewhere reading comments that right angled SMA adapters have a lower frequency limit than straight through ones; at least, the sharp angled ones like the two on the right of

some ideas an mesurements here : http://home.scarlet.be/~pin32100/Microwave%20roundtable/Measur.pdf F1CHF Envoyé a partir de mon Minitel S3B (version 4) -------Message original-------

Hi all forgot it's for 23cms Reg Sent from my Samsung Galaxy A3 - powered by Three

Yes and as I stated I won't post buyer must collect Reg Sent from my Samsung Galaxy A3 - powered by Three

…I assume you mean the one for 23cm. nick

Hi all I am selling my 67 ele wimo. I would recommend getting a new driven element. Best offer gets it. please contact me off forum. Buyer must collect as it's a tricky item to post Reg G8VHI. Sent

Hi Jim If you get this in time, can't offer a QSO, since I'm on 9cm tonight due to re flat-roofing, so no access to mast to swap dishes. Hope you get a fist-full of QSOs. CU

And I will just have 13cm.......... KST and watching for traces on the spectrum display. I can use both the 2300 and 2320MHz allocations. 200W and 67 element. 73 de Sam, G4DDK JO02pa

Hi Folks I'll be QRV on 9cm and 3cm this evening from JO02cg. Mainly setting up QSOs on KST, as I have no 144 talkback, but I will call towards centres of activity in various directions on 3400.123

Hi All I will be trying my 10G setup for the first time from Alport Heights, Derbyshire. IO93ga KST Only 07971 091767 Mark G0MGX