Thanks for the update. I've been missing I was thinking temperature problems. John G8IKP

Hi John Here's my (cunning) plan:- Callsign: G4ZTR Locator: JO01KW Band: 10GHz 10W 80cm offset dish Talkback: ON4KST, 144MHz Times: Various throughout Regards John

John Appears to be functioning fine here visually in IO74PC only 144Kms away but through a 230 metre very steep hill. Screen shoot attached. As to strength looks about average but about 30dB

Callsign: GW4MBS/P Locator: IO71XW Bands: 5.7GHz 8W 65cm dish 10GHz 12W 65cm dish Talkback: ON4KST, Zello SHF Chat Times: Morning & early afternoon 10GHz only Late afternoon

Hi Colin, it would be good to have some pointers to papers and documentation about how the various gyrotron variants all work. Most of the Google hits and literature searches produce

The recent query about G8MBU has reminded me to ask about GB3NGI on 23cms:- A couple of weeks ago I used aircraft scatter to compare a dish with a small box of yagis, and on both antennas I had

Thanks to all who have replied. 73, Phil G4LPP

Phil, Bob , G8MBU , emailed me last week to say he had no option other than to temp. turn off G8MBU as it is housed in a commercial premises and he was unable to add any more forced air cooling to

Callsign: G4BXD Locator: IO82UJ Bands: 10GHz 6W 46cm dish Talkback: ON4KST Times: Various throughout

Thanks very much for that Phil. Good to know it’s not my gear. Hope there’s no damage to the beacon. 73, Phil G4LPP

The next sessions of the UKuG 5.7GHz and 10GHz Contests take place this Sunday, 31st July from 0600 - 1800 GMT (0700 - 1900 BST). Entrants can operate for a maximum of 8 hours during the contest

Nope, the pin is outside the housing, I just undid the bolt four turns and the motor housing slipped off. The photo of the socket is the inside of the hole where the shaft fits. Pin

Or 85cm! David

Hello Group, I did have one and it counts up to 24ghz. 73 John PA7JB Op 23-7-2022 om 20:18 schreef Dr. David Kirkby, Kirkby Microwave Ltd:

Thanks very much Neil So I need to remove the plastic rear cover to gain access to the pin that's needs to be removed..?? Will have a look later... Howard

Would be nice to see a comment that the amateur market will still be serviced. David, G4YTL

Bolt is stiff, but only needs to undone about four turns, the end fits into a hole in the actuator shaft. There is a transverse pin in the end of the shaft which is LOOSE and will fall

Linwave is one of the group in the UK. They look impressive. Paul G8AQA On 25/07/2022 11:33, Neil Smith G4DBN wrote: Virus-free. www.avg.com

Thanks Neil, not sure that I am "excited" about this acquisition.by an "investment company expanding it's footprint". -- Clive GW4MBS (ex-G8ADP) Pottering on 6m - 3cm in a valley in IO71XW where any

Not audible here, usually audible…. Barry 2E0GTD, IO91GE18