GE gentlemen. I was wondering if someone could direct me to some example images, or a site showing how others have mounted their 10 GHz off-set dish to a 2" OD mast. I would like to incorporate

Hello John Thanks for the QSO on 3cm yesterday… 73 David Get Outlook for iOS

As with any plant they need harvesting. Paul G8AQA Virus-free. www.avg.com

GCT was a decent RS signal again here in IO93 last night, despite the direct path being totally blocked by trees. I'm taking careful measurements to see which trees I need to fell to open up the

Hi Dave , Yes the path to GB3GCT is heavily obstructed in my direction , 37.2 degrees from me at 84km . I have been surprised at the extent of RS returns from virtually all round the compass - far

Peter, this is something I have an interest in, would it be possible for you to send me that article as well? Best 73 Paul G3NJV

Thanks for the report John. Looking at the beacon site I'm not too surprised by your observations. The location is a local high spot but shielded to the North and South by the Berkshire Downs and

Apologies if I go into 'I've been though this before' mode ... I spent a lot of time looking at, and designing a reproducable LNA (<1dB noise figure using my HP source and NFomenter) using a modern

JLC is the supplier I use but, as I said, they have an engineering surcharge for 0.4 mm PCBs, hence my question.

And if you want really thin susbsrate jlc do 4 layer, with either 0.2mm top layer (jlc7638 layer stackup) or 0.1mm (jlc 2213 stackup) ... no use for the hmc pa chip, but useful for other microwave

I would really appreciate some input for Scatterpoint, due to be published next week. Such as This month I have been….. An article would be great. Or anything interesting……. Activity reports

Hi Greg JLC PCB does boards of both 0.4 and 0.6. Ive always had a great service form them but be selective on the postage to keep your costs down Chris MM0KOS Sent from Mail for Windows

Hello David There’s certainly a lot of rain around today, although so far Essex is living up to its reputation and is dry. I’m still learning about RS propagation, but my feeling is that

Aggressive drizzle here at moment . Once again it shows that it only takes minimal moisture to bring GB3GCT from normal below noise floor to a respectable level .My 60cm dish is also elevated to 4

I've now completed my 10 GHz transverter and am starting on an LNA and PA. For the transverter I used PCBs with a 0.8 mm FR4 substrate and, apart from the 1 dB per inch track loss, it seemed to work

Hello Bob, PA is sold and winging its way to downtown Leicestershire Sorry! Phil G3YPQ

David I might be around if there is something local to get me out the valley. -- Clive GW4MBS (ex-G8ADP) Pottering on 6m - 3cm in a valley in IO71XW where any QSO is a triumph of optimism over

Hello Robin, Thank you for the nice words. Enjoy you sailing trip and take care.. 73 John PA7JB Op 20-8-2021 om 19:00 schreef Robin

Hello... There’s quite a bit rain about tomorrow so anyone around in the afternoon on 10Ghz? I’ll log into KST when I’m about David – G4RQI IO93IR Sent from Mail for Windows

Nice units, i have one, not tested yet as i am sailing, but a really nice build-- Robin Szemeti - G1YFG