Andy Is your timing set correctly I jave you starting 5 seconds early and am not getting a decode Denis G0OLX

They shipped me some kit yesterday Robin, but tech queries can take some time. Not sure why the 3400 transverter has disappeared from the range, perhaps there is a G4 on the way? If the photo is

For the next hour or so. QO100 10489.984 Dial freq, Mode JT9D Just below the top beacon In the experimental section as I'm playing with something and don't want kewzos) Andy www.g4jnt.com

Does anyone know if the Kuhne G3 9cm transverters configured for 3456 MHz can easily be re-crystalled and re-tuned for 3400 MHz? I tried contacting Kuhne, but they have not answered as yet ...

I would assume it is just the other way around. Permanent voltage is the supply. The other pin is the enable. I think those amplifiers need a positive voltage to key, provided by their own

Thank you Neil. Much appreciated. Should be able to crack on now. 73 David G4GLT.

On the Kuhne PCB No. 03, there are steering diodes for the power supplies, highlighted in yellow. The "permanent" supply feeds a 78L05 and ICL7660 which generate the FET negative bias

My wife left me unattended for a few hours ... on a day when the Ramco auction was on. Silly girl. I am now the proud owner of: A small telescope collimator, a 10MHz GPS frequency reference which I

Hello, I am connecting up a Kuhne PA MKU PA 6CM -15W A. I am confused by their data sheet. It looks like the 12v connection labelled ‘+12v DC’ goes to a fuse then the supply voltage rail +12-14v

Andy Please put me down for 5 as well Many thanks Denis G0OLX

That's more like it :-) Any more ? Andy www.g4jnt.com

Put me down for five PCBs please Andy. Neil G4DBN

Not really enough interest been shown yet to justify a commercial PCB order. SO far five people wanting a total of 7 I want to make it worth while getting 50 or more made up. Newbury Electronics

We haven't said that they are not being recorded. Chris G0FDZ is giving his talk from last month at some other venues, the recording of his talk is likely to be available when

For info.... The UKuG calendar complete with full add-to-diary facilities is fully public here, not on groups.io https://www.microwavers.org/main/ Apart from talks/events it will in the coming weeks

Sorry I never said thanks for the reminder, it looks good

I bought this LNB with the idea of using it to get on 9cms. But as I've bought an SG-LABS it is surplus to requirements. I'm happy to pass it on for the cost of postage if it will help very someone

I measured 0.85dB nf on one where I replaced the wg feed with an sma, though that was 10 years ago! www.rfdesign.co.uk/microwave Roger G8CUB

I also have one of those LNB's which I had intended to use to monitor the Blackpool ATV repeater. But now just about all ATV has gone digital I've lost interest. I used the LNB to check the output of

It would also be nice if these and any events were put into the Calendar that comes with this list on groups.io. That way people can be automatically reminded of the event and, for