Re: Magnetron - coax transition


In a message dated 14/10/2008 18:31:56 GMT Standard Time, andy.g4jnt@... writes:
The only measurement that would be helpful for future is the probe
spacing from the rear shorted end of the waveguide. That assuming its
standard WR134 - it usually is, coz manufacturers like to make their
life easy and just take datasheet values
Hi Andy
Its gone to "cooker hell" - 8 amp fuse kept blowing and I just could not be bothered to try to locate the cause on one of the control boards.
Anyhow measured the probe distance  - 18mm. (centre of probe to rear wall)

Join to automatically receive all group messages.