Re: File /PICkit3 Programmer Application uploaded #file-notice


Just ignore it. I have had several that programmed at 3.3 volts OK.

Zack W9SZ

On Fri, Sep 3, 2021 at 4:56 PM Stefan <comlab@...> wrote:

Hi Zack , Hi All

Pickit3 reads the 16F877A ok when i want to write i get a warning that "This device requires a minimum VDD of 4.5V"
Just ignore that ? as the the chip is 16LV877A  LV for low voltage programming??

Regards Stefan 73

----- Original Message -----


Thu, 2 Sep 2021 16:32:03 -0500
Re: [The122GProject] File /PICkit3 Programmer Application uploaded #file-notice

Yes, I have done the same to generate the assembly language code for the PIC. I have done a lot of assembly language programming for PIC's over the years. It was pretty easy for me to do any modifications.

73, Zack W9SZ

On Thu, Sep 2, 2021 at 4:18 PM Mike Lavelle K6ML <miclevel@...> wrote:
Hi Stefan,

I've used the Microchip MPLAB IDE (v8.90, as it happens) with success.


On 09/02/2021 2:14 PM Stefan <comlab@...> wrote:

Hi all

I have installed the Pickit3 programm and it works like a treat! Thank you.
Would anyone know what complier would be required too modify the source code, rather figuring out the HEX.

Many thanks 73 Stefan

----- Original Message -----

"" <>

Wed, 01 Sep 2021 15:31:33 -0700
[The122GProject] File /PICkit3 Programmer Application uploaded #file-notice

The following files have been uploaded to the Files area of the group.

By: Zack Widup <w9sz.zack@...>

PICKIT3 stand-alone programming software

Email sent using Optus Webmail

Join to automatically receive all group messages.