Date
1 - 4 of 4
2465B display shift off screen
|
mill_glen_chevy
Hi
I have a 2465B on my bench that shifted the entire display to the far left when I turned my back on it. I can just see the ends of the traces at the left edge of the screen when I adjust the position far right. Any ideas where to start looking? -- Brian St Pierre
|
|
|
|
Jean-Paul
Bonjour, you have the schematics and service manual, beware of serial numbers ranges.
Same results at all modes, xy, sweep? Beam finder same results? Check all power supply voltages, then horizontal amplifier. probe the voltage on the horizontal deflection plates at the CRT neck. Bon courage Jon
|
|
|
|
John Gord
It may be the dreaded U800 horizontal chip failure.
toggle quoted messageShow quoted text
--John Gord
On Mon, Nov 9, 2020 at 11:21 PM, mill_glen_chevy wrote:
|
|
|
|
n4buq
Is it possible that the deflection plate connections have become disconnected or broken? I'm not sure where the horizontal plates connect on that particular scope, but if those are connected via the neck pins, it would be simple enough to check.
toggle quoted messageShow quoted text
Again, I don't know how those plates are connected so I might be way off with this. Thanks, Barry - N4BUQ
----- Original Message -----
From: "John Gord via groups.io" <johngord=verizon.net@groups.io>
|
|
|