I uploaded a photo of the badge on my 2465 at https://groups.io/g/TekScopes/album?id=275497 It's pretty good and could be made better with a little touch up using a photo editing program. Cheers, Tom

On Tue, Feb 15, 2022 at 07:27 PM, Mark Vincent wrote: "Renee and Tom, let us know how you are coming on your restoration since you to mentioned it. I hope you two get them going to your satisfaction.

Thank you David Templeton, Harvey White and Mark Vincent for responding to my 465B troubleshooting request. During my subsequent troubleshooting I found that, with the AC-GND-DC Switch set to DC, the

I am troubleshooting a 465Bs which suddenly lost the channel 2 display trace. I have the appropriate Tek service manual and test equipment including another working 465B. My current troubleshooting ap

Hello Mark Vincent, Regarding your post • “If you are going to go further when you get it recapped, I can give you a list of resistors that should be increased in wattage.” I am in the process of repa

Thanks for compiling the document Dennis. I know that it takes a lot of effort to do such projects.

Greg, Thank you for posting the link to the Jim Williams article. I saved many articles written shortly after Jim passed but I had never seen the 5 Years Later article. Cheers, Tom

CEDistribution & Tubes and More / Antique Electronic Supply are really the same company. The former is their wholesale outlet which sells only to registered distributors and the latter sells to the ge

Hi Jeff, I'm glad you were able to get the 475A working. Just to let you know...When you change the subject line the groups.io system starts a new thread that is separate from your previous postings o

Dave, Regarding your question "How are places like Mouser and Digikey with small time onsie-twosie buyers..." I have found that they are amazingly cooperative with small orders. I have been refurbishi

Hi Bill, Thanks for posting these. The reworks look really good. At my end the link to The Cathode-ray Tube Document is not working however. Cheers, Tom

I was able to free up a frozen intensity pot in my 465B. The 465B intensity pot is located near the rear of the interface circuit board. A long thin epoxy extension shaft connects the pot shaft to the

Hello Staffan, You said "This unit has quite a few coolers and they got reasonably warm just during the time it took to adjust the display." Those "coolers" are the heat sinks and the fact that they q

When I have seen suspicious ebay listings I have used the "Report Item" link on the listing page to inform ebay. The listing always disappeared within a short time. I'm not attempting to be an eBay po

I'm interested too. Thanks for bring the document to light.

I concur that the feet supplied by Jeff N0DY are great. I purchased two sets of feet for my 465 series scopes last January. The result was much better than trying to make some kind of replacement myse

Thanks Dennis. By the way, I would not assume that a gmail address is a "throw away." I recently switched to gmail as my primary address because my long term dedicated email address service had become

Regarding the concerns expressed about allowing attachments I suggest taking a look at how it is working out for other groups that presently allow attachments. One such group is HP-Agilent-Keysight-eq

I wholeheartedly agree that allowing attachments would greatly enhance the ability of users to clarify questions and provide responses. The old saying that a picture is worth a thousand words comes to

Michael, That was much more interesting than I expected. Thanks, Tom