I have two NOS fiber connectors which I'm pretty sure is for OF150. They are marked DEUTSCH DWR0004-08E. You could have them for the cost of shipping (from Sweden). If you are interested contact me of

The original protect board doesn't have those connectors. It is soldered directly to the square pins of the Readout board. /Håkan

There was a mod kit to install this board, 040-0769-00. Here's a short explanation included in the kit: //This modification kit provides parts and instructions to improve the reliability of the microc

The Service manual on TekWiki has the board layout at page 364 and parts list at page 338. /Håkan

I am surprised that the horizontal output amp U800 hasn't been mentioned yet. Unfortunately it is a common problem especially on newer models. Check the signal on the output i.e. on the horizontal CRT

I think you got the P/N wrong. In my manual it is 311-1848-00. There is one eBay seller in France that has one. http://www.tinyurl.com/4up7hxtj /Håkan

Yes that's how it was initially, to replace one or both connectors the whole frame with connectors had to replaced. However after a request from a field office, in Dec 98, in order to save time and ma

They can for sure be replaced. P/N is 131-6263-00. The old one can be pulled out and the new one will snap in when pushed. Pics: http://www.hakanh.com/temp/bnc1.jpg http://www.hakanh.com/temp/bnc2.jpg

I have this manual and I scanned it last night. These SonyTek manuals are not like the classic Tek manuals which could easily be disassembled for scan. They are genuine books with the pages glued to t

By Full adjustment I mean performing the complete sequences as described in the chapter named "Adjustment Procedures" in the Service manual. Yes, Factory Cal is mentioned a couple of times in this pro

Haven't tried this on a B or C scope so I don't know if it applies to them but the TDS200's and TDS1000/2000 no letter scopes require a full adjustment right after the change for it to stick. /Håkan

Some of the adj softwares, however not all, support some minor automation i.e. setting the test gear instead of prompting you for it. You could find out by edit the G_CONFIG file: Remove the star in t

Calibration and adjustment aren't nesseceraly the same thing. Adjustment should normally only be needed after a hardware change or if the scope doesn't pass Performance Verification. If it fails SPC i

Are you still looking for it ? If so have you seen ebay item 304784810398 ? It has just been relisted with no bids the first time. No connection to the seller just an observation. /Håkan

No, RPR /H

Should be: 7623A switched from 670-3683-00 to 670-2843-03 at S/N B183588. /Håkan

For reference: Standard TM506: 119-0026-00, 52CFM TM5003 & TM5006: 119-0721-00, 75CFM Rack option: TM506 & TM5006: 119-119-0147-00, 105CFM TM515: below B021180, 119-0026-00 52CFM, for replacement use

Both TM506 and TM5006 have different fans for the rack version and the stand alone. The rack fans are much noisier. /Håkan

My version: http://www.hakanh.com/dl/TDS7_LCD.htm /Håkan

Mod 104F: Provides independent remote single sweep reset via rear BNC. /Håkan