No, I did not do a YouTube video. But I've seen one out there. I didn't have a replacement cable or other parts. I cut my cable off at both ends as close as I could to the strain-relief parts, then te

Jeff, your probe is a 200mhz unit. I re-cabled a p6062 which is a 100mhz. However they appear similar and I expect are built about the same. I had a break. I cut the cable at both ends. There is a str

Hi John, The concept of the ring is to put it on or take it off, depending on the probe being used (1x or 10x). The scopes don't have a manual switch (like my modern cheap digital one does) to tell it

Hi David, Thanks, it's www.tekring.net The project started out quite simple. But it turned into a very deep black hole. The 3D print creates the "washer" itself (that part is simple). However, embeddi

I realize this is an old thread, but I've just repaired a p6129b probe. It has a readout pin, but the scope was not seeing it in 10x when the switch was in that mode. (it has the 1x /10x switch). In 1