Well, if you have an antique boat, you might want that old anchor to go with it!!

They make special motor spindle oils like "Mobile Velocite No.10 Mineral Base Oil," which is used all the time in industrial environments for high-speed spindles and motors. It is a 5W non-detergent o

Will this work in the older 2465A 'scope? GerryR

A little history first: Acquired the 'scope recently and everything was working fine. Old battery dated 07-87. Decided to change battery and took all known precautions, but somehow screwed up and requ

That's the problem, in the normal mode, the 1, 2 and 5 volt ranges are all off, for example, a 1V signal on the 1V per division scale, displays as if on the 100 mV scale, etc., so I am assuming the at

Another question or two for those in the know: At the beginning of the Cal 02 procedure, it states to connect a 0.5 V standard-amplitude signal to CH 1 and to use CH 2 Position to vertically position

Chuck, Are you saying that the scope CH 1 & 2 inputs will be in 50 ohm mode for all the Cal procedures? I did check the inputs in normal mode when switched to 50 ohms, and they are both OK, right at 5

Would the SMT Station Monitor from www.preciserf.com help with your needs? Regards, GerryR

I just received a manual for an older Wavetek Pulse Generator, from Artek Manuals, on CD. Very high quality and complete. I have no affiliation with them, but definitely recommend them. The sections t

I'm looking for a source for the small knobs that are under the CRT display (scale illum, focus, etc.). I need one, but would like to get at least one more to have as a spare. Also, looking for the pl

I'm not at all familiar with this type of coax. What is the core material, and what makes it so good at the higher frequencies? GerryR KK4GER

Thanks Dennis, After I asked the question I did look up the cable and found out its characteristics. I've spent most of my career (now retired) in industrial electronics / control systems, so some RF

Dennis, Thank you again, but just for the record, I was not referring to Leo's design. When I went to his website, I realized that his design was much different than the tunnel diode pulser. It was ac

You probably don't want to take the chance, but if you can't find anyone local to make the copy, you are welcome to send it to me and I would be happy to copy it for you. Also, I haven't checked for c

You only have two choices, 0.5 V per division and 0.1 V per division by the two small button / switches beside the position controls. Of course, with a 10X probe, you can multiply that. Besides good t

I can't see any attachment. If you have the drawing, can you email to totalautomation1 at gee mail dot com. Thank you. GerryR KK4GER

I'm pretty sure that the slots can be done, too, but from the drawing, it looks like the part is a perfect candidate for a Swiss Screw Machine. If I was to make this part, I actually would try making

If you look on page 7, remove part 3, the retractable hook, and then you have to unscrew part #4 to then slip the ground ring off. GerryR KK4GER

When I had my 2465A apart to replace the battery and for calibration, I used an infrared temp probe to monitor the U800. The max temperature it reached after a couple hours on-time was 135 deg F. Once

I have the 2465A manuals, op and service, and can not find any of what Mr. Panos sited in his inquiry, as well. But the manual I have is accurate as applied to my 2465A 'scope. GerryR KK4GER