As far as I know the P6137 is a 10x only probe, not switchable between 1x or 10x. It should have the spring loaded identifier pin next to the BNC connector to tell the scope to change the

Ok. So no where near me in Boston. I have two 547s. I haven't started to dig into either. But the idea was to pick one as the primary and the other as the parts horse, if I needed a parts horse. But,

Everybody is always looking for unobtainable Tek and HP CRTs, here’s what we will be clearing out at Stuff Day., along with MANY generic types which will be posted to the Remote Stuff Day Page.

I am in Ghana

Your message woke me up for a test: My test tips (p6137) do not have an X1 - X10 key. Is it possible, using these test tips, to have this option?

Hi Chuck, Thanks for this great explanation, and sorry for the detour in this thread. Another example of RTFM on my behalf... Un saludo, Leo

The Auto Measure mode only works with CH1 and CH2 inputs. If both CH1 and CH2 are selected, CH1 takes priority. In the Auto Measure mode, there is a button all the way to the right called

I have no X1, X10 probe. I only have the original P6137 and they do not have this key. In my case, I have already tested the inputs individually, and both channels do not work (1 and 2). Thanks.

Thanks for confirmation Chuck. I bought the IC U500 yesterday, I will wait to receive it and after that I will update the result. Thank you.

Hi all, this may be relevant to the measurement problem in this thread: While I was tracing why my 2465B would not switch the sensitivity readout when a 10X probe was connected to Ch1, I stumbled on

The scope settings section should have you set the scope into a setting where the waveforms would both be present... but Tek did make a few mistakes in that area. The B gate is only active when the B

Mine arrived with an incorrectly-sized line fuse. When I figured that out, I installed the current size fuse and it has worked fine ever since. DaveD -- This email has been checked for viruses by

Ditto, I nearly bought one of the eBay ones but wasn’t quick enough.

Oops, my bad. That should have read "bridge rectifier". Colin.

My 7104 did just that , it was the line filter going bad Brian

I saw that, too, but note "When powered on the item trips the electricity", despite the "seller refurbished" description. It could just be a bridge diode, but it could be more serious. Colin.

Where are you located?

Hoping that someone has a Tek 492A, 492AP 494A junker that will part with a 119-2008-00 Calibrator module. Mine has a Tek custom hybrid IC that is defective and the part cannot be found anywhere.

Can someone recommend a store for me to buy 547 scope HV transformer

Hello group, A friend handed his Quickstart III Demo Board (671-2679-00) to me for free but without a manual. Is there a way I can get one.