On both of these Chan 1 only passes the DC portion of the input. Connecting Chan 1 to the built-in compensation reference I get a 2.5 Vdc trace (which is the DC component of the 5Vpp square

Does anyone know a good cross for the Tektronix transistor N101 (151-062)?

just do a search on Amazon's (US only) site for TM500x -  comes up as second item, gets beat by a TM500XL TomTom battery!

THANK YOU KURT FOR CREATING MY FAVORITE TEK SITE, TEKWIKI. It is a complement to you that TEKWIKI is every bit as good as Wikipedia. I, for one, am amazed at the quality and professionalism of

Anyone looking for a replacement hinge cover for 465/475 series scopes, try

It is my standard policy to replace all SMD capacitors with regular leaded (legged) capacitors, soldered onto the SMD pads. It is a reliability issue, the cosmetics are completely irrelevant. On most

Many commercial 600 ohm terminators are overpriced but Broadwave have them for $25:

Thank you Kurt... for all that you do for the worldwide Tektronix community! tom jobe...

Kurt tell me how to register Marco Re Inviato da iPad *********************************************** Prof. Marco Re Associate Professor, Ph.D. Digital Electronics, Digital Signal

I will very happy to help you. Marco Re Inviato da iPhone

Primarily because it is quoted ASCII unicode, and the internet is ASCII. That is what all of the %3D's, %2C's, %3A's, etc... are all about you need to convert the hex numbers they represent into

Hello, I am one of the maintainers of the Tekwiki site. The URL is: http://w140.com/tekwiki Since 2008, Tekwiki has hosted descriptions of Tektronix instruments, photos, manuals, ROM images, and

This is a little overboard in options (see link below)... though is interesting considering USB 2.0 and 3.0 though the limiting transfer rate is going to be the oscilloscope so not really as

Ditto here doesnt point at anything here either? -- Dave Manuals@... www.ArtekManuals.com

This is the link that is working for me (thanks, reminded me I needed to order a 20 pin edge connector also for a different

Your link points to a blank page in my browser. Sent: Sunday, January 07, 2018 3:26 PM To: TekScopes@groups.io Subject: [TekScopes] TM500 / 5000 Extenders I've offered these in the past. I made

My guess would be a high dollar BNC with a Teflon insulator. Sent: Sunday, January 07, 2018 3:08 PM To: TekScopes@groups.io Subject: Re: [TekScopes] SG505 Output voltage too high [RESOLVED] It

Local delicacy... Yummm! -Chuck Harris Adrian wrote:

I've offered these in the past. I made them for my own use, and for forum members. Since then I have become an Amazon seller so I've added the new updated version of the extenders there (see link

I make Terminations by soldering a 1/2W resistor in a BNC connector. Solder one end to the pin, insert into the connector and fold over the other end and solder it to the connector shell. Make sure