I have run across at least 4 different files but I think they all originate from a single scan.

Triggering has no meaning in X-Y mode except in that the trigger source and trigger coupling affect the X input. The vertical delay line and to a lesser extent low horizontal bandwidth limits X-Y

Hello Peter, The manual (for S/N B250000-up) specifies the X-Y phase angle typically less than 3 degrees up to 50 kHz. That would be very well visible, ellipse opening (hor. or vert.) I think about

It is just a very different design with much less stress on the individual parts. The price for this is having to include a large 60 Hz power transformer. The 2225 series has also not aged quite

Unless they are used for timing like in a soft start circuit, the values are not critical. Larger values are better up to a point. For local bulk decoupling capacitors, values are usually

With higher voltage ratings up to about 100 volts, dissipation factor and ESR drop and ripple current rating increases. Ripple current rating depends on ESR and surface area for dissipating heat.

Hello, my name is Peter Hendrickx. I’m a European who lives in Canada. I have worked for 22 years in cable TV for testing and repairing measurement equipment and amplifiers. I’m licensed ham

Just go up to 15uF, or 18uF, or maybe even 20uF. Odds are that the old part was -10%,+100%, so an 18uF part would likely be spot on, and 20uF would not harm any. These are after all just decoupling

various places. I should replace them as well? I'm not wild about removing the attenuator/timebase board, though it's probably easier than it looks. Hi Phil, Sorry for not being clearer about my

Sure this does show on the outside. Just compare the photo in "Engine Analysis Measurements" (Measurement Concepts Series) with an ordinary 2B67. For example, the text mentions a Rotational Function

After a marathon session at distributor's web sites, I found a number of perfect fit replacement caps but still missing a few. What is glaring is the absence of axial cap selection. It looks

I have also Tektronix 067-0513-00 with broken original tunnel diode. I have installed tunnel diode 1N3718 to GR-874 connector. Rise time is now 800 ps. Eino

Hi Dave, I had a 502. Bought it from work for $400 about 1967. Very sensitive input (100uV to 100KHz) and max B.W. of 1MHz on higher ranges. Limited use for me and ended up giving it away some

Thanks. I went through Mouser looking for the caps. 300 mil pitch doesn't seem to exist anymore. Will try Digi. On higher voltage caps, it's it the case the higher V often means higher ESR? I am

Crikey! Dave's Australian speech makes for entertaining listening but I can understand how it would get old after a while. The same thing happens to me if I binge watch Doctor Who episodes. Damage

Oh, and I forgot to mention that this is not something I would worry a great deal about. Even without adjustment, the Agilent probes will be close and you are unlikely to be measuring any signals

Alternatively, the UKP50 pulser we discussed a month or two back that does

Thanks, David, Tom, Tom and Glen. I've seen those videos. Dave's tear down is really good though my wife makes me wear headphones for any of his videos - she's a non-fan. I kind of get her

Pardon, two of the 067-0513-00 pulse generators that David mentioned wanting to see the inside of. Which can be arranged, as I have two of them. -Chuck Harris Jeff Davis n0dyjeff@...

Not sure what exactly you have two of... 😊 I've posted some test results from two samples of the build I did following the notes from Sergey Kubushyn. The test was conducted over the noon hour on