Hi Raymond, I have a 318, but don’t recall if there’s a manual in the top zippered pouch. I’ll check and if so look at how feasible it would be to scan it. Personally, I’ve never looked for

And one more point, Roy: The short answer is: dunno. It's my experience that often, wading through an operator manual saves time in getting acquainted with a piece of equipment, even if I know how it

Hi again Roy, 1 mega-sample? Raymond

Hi Roy, You're frighteningly close to touching on the very reason for groups like this to exist... Raymond

Power supply measurements not bad +12V measured +11.98DC 0.001AC ripple -12V measured -11.73DC 0.001AC ripple +200V measured 211.4VDC 0.386AC ripple -30V measured -29.97DC 0.001AC ripple +30V

Well, if you regard signature analysis as fun, then you can do that. The 308 was more limited, but if you're looking at vintage electronics that uses signature analysis, that's not a bad thing to

Hi: It seems the Army one has a reasonable operator's section (Chapter 4?). What part isn't detailed enough? My question is why: what can one do with a 50 MHz (1 mega-sample) logic analyzer...that you

This generator was designed as a sales tool, to be used to demonstrate a particular feature in the TDS600 series which had a competitive advantage at the time. I don't recall the feature, perhaps

Bill I (and I am sure Q-Service does too) appreciate your moral character... 8^) Dave ArtekManuals -- Dave Manuals@... www.ArtekManuals.com

Dave: After researching the source of this 7104 manual FEB 1989 I see that I did buy it from QSERVICE Nikolaos Kapetanakis for $US 9.49. So I don't feel good at all in sending this PDF to anyone

Good job!!!!! -----Mensaje original----- De: TekScopes@groups.io [mailto:TekScopes@groups.io] En nombre de scskits Enviado el: martes, 9 de octubre de 2018 23:47 Para: TekScopes@groups.io Asunto:

Thanks!! Now is working, some traces in option board were shorted, manufacturing defect in PCB, I was going crazy, I almost did not see it. Some

Solved.... After tearing into the PG506 for a while and re-verifying the divider networks to no avail, I discovered a bad BNC cable between the 3456A and GenCal resistor decade I was using. The darn

If not too off-topic (it's not a 'scope, really, and too digital): Does anyone have a PDF of this available? The Service Manual (military version) is available on the Internet but as indicated, I'm

I will check the power supply for ripple and invest in a LCR meter to check the capacitors. It seems they make 100 kHz LCR meters you can check capacitors in circuit, maybe I will take a look at

Really good info - Thanks - I was about to make up one of those kits

Thank you. Yes I saw that page before, but info is still very limited. Was hoping for a spec sheet or manual.

Maybe Q service? Dave ArtekManuals -- Dave Manuals@... www.ArtekManuals.com

Ditter, To which extender kits do you refer? DaveD

A word of caution about these extender kits. I have seen these postings on e-bay from time to time and noticed that these kits use a simple circuit board whose edges are either sheared or more