|
Re: [HP-Agilent-Keysight-equipment] OT: Looking for a Pentium M765 (or maybe M780 - not sure it that will work)
This might be a dumb question, but why not get a different motherboard?
<david.partridge@...> wrote:
This might be a dumb question, but why not get a different motherboard?
<david.partridge@...> wrote:
|
By
cheater cheater
·
#184572
·
|
|
Re: ++Processor error on TDS 754D on startup
That sounds like a plausible theory, all though, what you described as a crc is really a checksum. A crc is similar but much more stringent. It is a polynomial with a characteristic divisor. In
That sounds like a plausible theory, all though, what you described as a crc is really a checksum. A crc is similar but much more stringent. It is a polynomial with a characteristic divisor. In
|
By
pmoyle111
·
#184571
·
|
|
Re: Tek 2230 Repair and Maintenance
Bert, Jeff, and Albert, thank you for the response.
Bert, I am planning on replacing the line caps. Seems to be the No.1 item to address during my research. Definitely not leaving that out! I have
Bert, Jeff, and Albert, thank you for the response.
Bert, I am planning on replacing the line caps. Seems to be the No.1 item to address during my research. Definitely not leaving that out! I have
|
By
Charlie
·
#184570
·
|
|
Re: TM 504 Power Module Questions
I used coax but even so the environment back there is so electrically noisy that the THD measured via the backplane is significantly higher than when connected around the front with BNC
I used coax but even so the environment back there is so electrically noisy that the THD measured via the backplane is significantly higher than when connected around the front with BNC
|
By
EJP
·
#184569
·
|
|
Tek 494AP VR board mystery
Can somebody come out with any reason for the CR3068 diode on VR 2nd Filter
Select board (left bottom corner on the schematic on page 185 of 494A/AP
Vol.2 Service Manual)?
There are 5 filters there,
Can somebody come out with any reason for the CR3068 diode on VR 2nd Filter
Select board (left bottom corner on the schematic on page 185 of 494A/AP
Vol.2 Service Manual)?
There are 5 filters there,
|
By
Sergey Kubushyn
·
#184568
·
|
|
Re: OT: Looking for a Pentium M765 (or maybe M780 - not sure it that will work)
I have the following CPU's spare if any of these will be of use:
1x SL6F9 - M705
1x SL7EG - M725
1x SL7SA - M740
2x SL7EN - M745
1x SL7V3 - M765
1x SL7VB - M780
I'm sure I could send one or two
I have the following CPU's spare if any of these will be of use:
1x SL6F9 - M705
1x SL7EG - M725
1x SL7SA - M740
2x SL7EN - M745
1x SL7V3 - M765
1x SL7VB - M780
I'm sure I could send one or two
|
By
Jared Cabot
·
#184567
·
|
|
Re: OT: Looking for a Pentium M765 (or maybe M780 - not sure it that will work)
David, here is the chip data. Lots of info to be found using a search. I have several Dell desktops and HP laptops from that era but you need to state if it is a desktop board or a converted laptop.
David, here is the chip data. Lots of info to be found using a search. I have several Dell desktops and HP laptops from that era but you need to state if it is a desktop board or a converted laptop.
|
By
Bill (Doc) Courtright
·
#184566
·
|
|
Re: OT: Looking for a Pentium M765 (or maybe M780 - not sure it that will work)
Hi David I have 8 Pentium, 4 Pentium 3 and 2 Pentium 4. But none
have a M in their markings like M765 or M780.
Have a couple 1 gb 2700 and 1 3200, several 512mb of this speed.
Have 5 AMD processors
Hi David I have 8 Pentium, 4 Pentium 3 and 2 Pentium 4. But none
have a M in their markings like M765 or M780.
Have a couple 1 gb 2700 and 1 3200, several 512mb of this speed.
Have 5 AMD processors
|
By
shalopt
·
#184565
·
|
|
Re: ++Processor error on TDS 754D on startup
Looking at what I think is going on, it's possible that the processor was in the middle of writing to NVRAM and corrupted the process. (it's write, and then write a checksum to validate the data).
Looking at what I think is going on, it's possible that the processor was in the middle of writing to NVRAM and corrupted the process. (it's write, and then write a checksum to validate the data).
|
By
Harvey White
·
#184564
·
|
|
FIXED! Shock Mount Replacement for Type D and Type H 500-series plugins (was [TekScopes] Another interesting Tektronix web site)
FIXED!
"DJI ZH3-3D Damping Rubber Set (Part 42)", less than $10 at ebay.
This is four bags of four different isolators, for an RC helicopter camera mount, one of DJI’s “Zenmuse” series.
The
FIXED!
"DJI ZH3-3D Damping Rubber Set (Part 42)", less than $10 at ebay.
This is four bags of four different isolators, for an RC helicopter camera mount, one of DJI’s “Zenmuse” series.
The
|
By
Dave Wise
·
#184563
·
|
|
Re: Members in Germany, Brussels, and the Netherlands affected by the floods
Dennis,
in the affected regions is no power, no internet, no water, no food.
So it will take some time to reach the people.
Peter
==============
Dennis,
in the affected regions is no power, no internet, no water, no food.
So it will take some time to reach the people.
Peter
==============
|
By
Heinz-Peter Deutsch
·
#184562
·
|
|
++Processor error on TDS 754D on startup
Last winter we had a power outage where the power co would turn power on for 15 min ever hour or so. The scope was soft turned off by the front button. Since then I have been getting the error message
Last winter we had a power outage where the power co would turn power on for 15 min ever hour or so. The scope was soft turned off by the front button. Since then I have been getting the error message
|
By
pmoyle111
·
#184561
·
|
|
Members in Germany, Brussels, and the Netherlands affected by the floods
If you are in the region affected by the flooding in Germany, Brussels, or
The Netherlands pleased contact me (dennis at ridesoft dot com) if there is
anything I can do or TekScopes can do to
If you are in the region affected by the flooding in Germany, Brussels, or
The Netherlands pleased contact me (dennis at ridesoft dot com) if there is
anything I can do or TekScopes can do to
|
By
Dennis Tillman W7pF
·
#184560
·
|
|
Re: A high-priced Tektronix RM504
And Cordwainer Bird is still collecting residuals.....
Harvey
And Cordwainer Bird is still collecting residuals.....
Harvey
|
By
Harvey White
·
#184559
·
|
|
Re: Smoke damage 7704A
My deepest condolences on your loss, Gordon. It's hard enough to have to put a dog to sleep, as we did last weekend, but to lose your wife wow, I can only imagine! Feel free to PM me if you want
My deepest condolences on your loss, Gordon. It's hard enough to have to put a dog to sleep, as we did last weekend, but to lose your wife wow, I can only imagine! Feel free to PM me if you want
|
By
Jim Ford
·
#184558
·
|
|
Re: Smoke damage 7704A
Nope.
It was Kelite (not Kellite)... lot's of stuff pops up including the logo "Scientific Cleaning Through PH Control."
Anyway... it was just a buffered alkaline detergent... nothing special.
--
Nope.
It was Kelite (not Kellite)... lot's of stuff pops up including the logo "Scientific Cleaning Through PH Control."
Anyway... it was just a buffered alkaline detergent... nothing special.
--
|
By
Roy Thistle
·
#184557
·
|
|
Re: Smoke damage 7704A
I use Simple Green all the time when giving a rig a bath. It doesn't always get rid of tobacco stench, but if followed by another rinse with ammonia everything smells great. I collect water from my
I use Simple Green all the time when giving a rig a bath. It doesn't always get rid of tobacco stench, but if followed by another rinse with ammonia everything smells great. I collect water from my
|
By
greenboxmaven
·
#184556
·
|
|
Re: A high-priced Tektronix RM504
Yup... humanity escapes a toxic Earth (where it's still possible to live) to go to Io to die for certain... where the razor thin atmosphere is almost all sulphur dioxide, and Jupiter's intense
Yup... humanity escapes a toxic Earth (where it's still possible to live) to go to Io to die for certain... where the razor thin atmosphere is almost all sulphur dioxide, and Jupiter's intense
|
By
Roy Thistle
·
#184555
·
|
|
Re: Smoke damage 7704A
Hi All,
For cigarette smoke smell and tar removal, I can most enthusiastically recommend Simple Green. My dearly departed wife was a 2 pack a day smoker (Yep, the smoking was the root cause of her
Hi All,
For cigarette smoke smell and tar removal, I can most enthusiastically recommend Simple Green. My dearly departed wife was a 2 pack a day smoker (Yep, the smoking was the root cause of her
|
By
Gordon, KJ6IKT
·
#184554
·
|
|
Re: Smoke damage 7704A
It doesn't dissolve in water... it's a terpine oil... dissolves in alcohols (among other things.)
It also "eventually?" attacks brass, copper, cast iron, rubber, silicone... and some plastics... but,
It doesn't dissolve in water... it's a terpine oil... dissolves in alcohols (among other things.)
It also "eventually?" attacks brass, copper, cast iron, rubber, silicone... and some plastics... but,
|
By
Roy Thistle
·
#184553
·
|