I am interested in one. Do they have any numbers on them? Glenn -- ----------------------------------------------------------------------- Glenn Little ARRL Technical Specialist

I have a 5103/D10 with problems with the range switches. I'd like to find instructions on how these should be adjusted. My attempt so far has had mixed success. I'd fix some range steps and others

The P7001-equipped 7704A does indeed stand out (pun intended) and looks strange in the beginning but it grows on you, especially in the vicinity of standard-height 7000's. Of course, speed and

Using the acquisition part of a 7704A, as I mentioned in an earlier message, of course is out of the question as a general solution. That's why I like your idea and project. I have a few Tek-7000

Definitely interested !!

Hi Ernesto, I have multiple 7000 series scopes. My 7613, 7633 scopes have a 10-20 mV low frequency noise on the vert signal output, I could not figure out why and give up on the idea sending

Raymond, The 7704A is really an interesting instrument where the two halves are interconnected by a single edge connector with a couple of coax connectors attached. I also played with the idea of

Thanks All for the response. The current status is: 1. The DC DC converter can only put out 10W at the moment and the controller chip overheat, the requirement is 16.5W. This partly due to the

Hi Reginald, Have the 7K extenders all been accounted for? Is there one still available? I would appreciate one please. Regards Bernard

For this, it may be worthwhile to have a look at the 7704A. This model consists of a lower acquisition module and an upper display module with a single plugged connector in between: after unplugging

would work. Does anyone know? I did some searching around before I made my 7k_flex extender kits in 2012. Couldn't find anything so I asked a Taiwan company if they could make it and they said they

Hi Yang, I think that you have a great idea of using the refined functionality of 7000 series plugins so that they benefit from unique features of a digital scope, like the ability to store nearly

Yep, I had a moment where I was wondering with the Tektronix D14 design (?) and started reading into more regarding anticipation if I might need for the 5000 and 7000 series mainframes. Wound up

Oops - I think I just realized the answer to my edge connector question must be yes, since people have been building 7K extenders for some time. I have some original Tek ones, so never needed to look

Unfortunately, it's not as simple as just providing power and an output interface. A lot of EMC cleanup will likely be needed for these desirable plug-ins to attain their normal performance. The main

Hi Reginald, I believe the 577, unlike the 576, is much more repairable for several reasons: * It came out later than the 576 so it is not as old; * It was specifically designed to use common Tek

HI Yang, WOW What a great idea! Congratulations on coming up with a wonderful project that will let everyone take advantage of some great Tek plugins. At least at first, to prove your concept is

I'm interested... what series scopes are they for? glad you got to him before he committed sacrilege

I'd like one also though don't need and am wondering how much he's asking since would be more a rescue in my situation.

I, too, would be potentially be interested in 7k series extenders.