Re: Seek Horz mode switch for R7704


Miroslav Pokorni
 

I found hot melt as very helpful when there is not enough material for
welding with soldering iron. Hot melt sticks quite well to most plastics,
the only draw back is that it can get bulky.

Regards

Miroslav Pokorni

----- Original Message -----
From: "zenith5106" <zenith@telia.com>
To: <TekScopes@yahoogroups.com>
Sent: Monday, November 17, 2003 3:29 PM
Subject: [TekScopes] Re: Seek Horz mode switch for R7704


--- In TekScopes@yahoogroups.com, "Jeff W" <vwthingy@c...> wrote:
Hi all,

I'm fixing a R7704 that is in need of a replacement horz mode
switch. It is stuck on "B", and even if you pull out the B switch,
internally it will not switch. (I shudder when I think about
taking
it apart, what with the grain 'o wheat bulbs, plastic welds, etc).

Tek P/N is 670-1330-00. I don't know if it is special to the R7704
(I
checked my 7904 switch, and it looks physically similar but is
different P/N)

Anyone have a swtich they'd be wiling to part with?

TIA


Jeff
---------
It's not a big deal to take it apart. If you cut around the plastic
welds and leave as much as possible of the plastic you will be able
to seal it again (once) with a soldering iron. The problem may be if
there is a broken switch inside.
/Zenith

Join TekScopes@groups.io to automatically receive all group messages.