Re: Big Cap for 465M--outer lugs

Miroslav Pokorni

You forgot to say that those caps charged to 160 V or so. You could not miss
the hint that cap was charged even if you wanted to.

I would think that TVs used single sided PCBs, so it was common to use
components as bridges, to allow room for one more trace to go through.

Miroslav Pokorni

----- Original Message -----
From: "Mark Anton" <>
To: <>
Sent: Sunday, November 16, 2003 9:00 PM
Subject: RE: [TekScopes] Big Cap for 465M--outer lugs


Have read other email response to this and think misunderstood...prob not
connect from top to bottom side of board...but simply to connect a
path on bottom side of board..Have run into this on older tvs too that
can capacitors.

The 4 outer ground tabs may not all be connected by one foil, and if you
a cap with just 2 leads, you might have incomplete ground path. The
original was depending on the tabs of cap to be soldered to
this one hard old sylvania tv was like that....the rectifier
charged up the cap but no load. so wondered why set didnt work. Well
cap held on to charge. And i that was fastest i moved in awhile :)

Mark Anton, Owner
Heights TV & VCR Service
3946 Central Ave. NE
Columbia Heights MN, 55421

Phone is 763-789-1767

(area code formerly 612)

----Original Message Follows----
From: "Earthlink" <>
To: "Stan & Patricia Griffiths" <>
CC: <>
Subject: RE: [TekScopes] Big Cap for 465M
Date: Sat, 15 Nov 2003 23:07:23 -0800

Thank you

I went ahead and found a replacement from digikey for about $5 + S&H. The
neat thing about it was

1) I got a 105C cap
2) its allot smaller so I think it should last longer being farther away
from any warm things in there.
3) it was pretty easy to solder in

Things to look out for

1) those darn horizontal and vertical "plugs" underneath that coil of coax
on the vertical amp board...who designed that blasted layout!?! Jesus,
a pain!!! one broke off....the manual does not jump out and tell you
exactly where those plugs are located...resoldering was abit inconvenient

2) When subbing for a old metal cap be sure to put in any required jumpers
from the vacated solder points. Those tek guys used the cap cans to get
one side of the board to the other.

Compare high-speed Internet plans, starting at $26.95. (Prices may vary by service area.)

Join to automatically receive all group messages.