Re: Clean and Lubricate Pots in Tek 475


 

Eric and Greg,

The recommendation for WD-40 comes directly from the 475 Oscilloscope Service Manual, page 4-2 under Maintenance, Cleaning, Switch Contacts, the exact passage reads "There are three recommended switch lubricants. They are Silicone Versilube (General Electric Co.), Rykon R (Standard Oil), and WD-40 (Rocket Chemical Co.)." So, while Tektronix DOES specifically recommend WD-40, it is not recommended for this use. The manual specifically says of the potentiometers in the unit "most of the potentiometers used in the 475 are permanently sealed and generally do not require periodic lubrication." Of course the period that they were considering was presumably much shorter than 50 years.

I've ordered a set of syringes and industrial needles to try either forcing some lubricant down the shaft, or into a the partially opened back end of the modular pots. I would like to order some DeoxIT to use in place of WD-40, but the range of options, and CAIG's claims for the product, give me pause.

I'm not too worried about using WD-40 on the unit in general, and I'm not terribly concerned with preserving these specific three pots, as there appear to be readily available replacement units at reasonable prices (I am going to order a full set of replacements for these three pots under any circumstance. The channel #1 vertical position pot can be easily replaced without even removing the vertical input board from the unit, and that is the one that is giving me the most trouble. The channel #2 vertical position pot is not as troublesome, and I don't use the beam intensity adjustment, which is the one with most serious problems, nearly as often as I do the vertical position adjustments).

Join TekScopes@groups.io to automatically receive all group messages.