Re: smd precision resistor "paint layer" peeled off while soldering *** advice needed ***


Chuck Harris
 

I would make both resistors the same... besides, you can't buy
just one SMD resistor.

-Chuck Harris

Rogerio O wrote:

Thank you all for the replies.
I am not sure of what to use as a replacement part.
I have ordered the KOA RN732ETTD1002B25 part from Mouser, which was the closest to the spec I could find.
Is it adequate? Any other better replacement?
Do I have to replace both R2012 and R2013 or just the one that has been compromised?
Roger





Join TekScopes@groups.io to automatically receive all group messages.