I’ve been fooliwing this thread but not really paying close attention.
toggle quoted messageShow quoted text
I assume that you’ve tried the DC-503 in all mainframe slots?
On Aug 11, 2020, at 04:29, Stephen <stephen.nabet@...> wrote:
On Mon, Aug 10, 2020 at 09:24 PM, Dave Daniel wrote:I will certainly do that and report back.
I would make six measurements with an oscilloscope:
- Measure the signal of pin 6A at the backplane where the connector is
soldered to the motherboard with the extender disconnected
- measure the same signal at the connector contact (front side)
- with the extender inserted, make the same two measurements
- with the extender inserted, measure the signal on the extender contact on
the plug-in end
- measure the signal at the plug-in itself (“after” the extender)
Thank for the suggestion, Dave.