Re: 2465 Fan Collet Thingy


EricJ
 

He probably made them himself. This part is so small I don't think the
weight will make a difference to the motor bearings. If nobody else has
time I could make some.

--Eric

On Sun, Aug 9, 2020, 9:32 AM victor.silva via groups.io <daejon1=
yahoo.com@groups.io> wrote:

On Sun, Nov 10, 2019 at 01:46 PM, Siggi wrote:



I did machine a batch of these collets from delrin/acetal, and those will
work just fine - delrin will hold the thread just dandy. (I've been
shipping these out for postage, but I'm out of stock now - alas).

Siggi
Siggi,

Will you be having more produced? Depending on the cost I would like to
have 10 or 20.
If you aren't about to order some, can you release the manufacturer of the
Delrin collet to sell some to a third party?
I would place the group order myself.

Although I collaborated with Tom Jobe for the design of the Brass collet
that led to the 2D in the files section,
I never liked the fact the initial samples were made of brass. Brass made
the impeller much heavier than it needed to be
putting unnecessary stress on the motor bearings.

Thanks,
Victor



Join TekScopes@groups.io to automatically receive all group messages.