Albert,

R1478 which should be 3.6 ohms measures 3.2 on analog, 3.6 on digital.

R1468 which should be 0.6 ohms measures 0.7 on analog, 0.7 on digital.

So not far off. I do trust my analog more because it doesn't bounce around like the digital. In fact, I measured again just now with the digital, and could not get a reading above zero on either resistor, while the analog repeated the earlier readings. Pfft! I probably need a better DMM, but used Fluke 87 III's are about $100. Any suggestions?

Thanks,

Bruce