Re: Fast Rise/Fall Time Pulser

Dave Wise
 

Even a 1/16" spring-loaded aluminum heatsink clamp is ungainly when you're working at this scale.

Dave

-----Original Message-----
From: TekScopes@... [mailto:TekScopes@...]
Sent: Thursday, October 12, 2017 9:44 AM
To: TekScopes@...
Subject: Re: [TekScopes] Fast Rise/Fall Time Pulser

I had Tek issue artery forceps circa 1969 that could be clamped on the lead of some tender little device while soldering to provide an alternate heat flow path.
Bob.


From: David Wise david_wise@... [TekScopes]
Sent: Thursday, October 12, 2017 9:26 AM
To: TekScopes@...
Subject: RE: [TekScopes] Fast Rise/Fall Time Pulser


Dennis, I think you're thinking of the 067-0681-01 TD Pulser. That's the John Addis design with 43-ohm resistor in the BNC.

I wonder if soldering the TD could be made safer by having an assistant spray the body with freezer while you solder the lead.
That's assuming steep gradient is less of a danger than overheating.

Dave Wise

Join TekScopes@groups.io to automatically receive all group messages.