Re: X-Y mode for Tektronix 2465A

Mark Huffstutter

If You don't have a copy I've attached
the page from the 2465B manual that
speaks to XY operation. This works on My 2465.

If You are comparing channels 1 and 2, only CH2 should be selected in
Vertical Mode. You should not ground any inputs,
that is Your comparison signal.


At 12:33 AM 3/22/2016, you wrote:

Gary, thanks for the suggestion. Yesterday we
tried all possible combinations of turning off
CH1 and CH2. Also setting the input of CH2 to
GND. But we'll double check, just to be sure. Any other ideas? Cheers, Bruce

[Non-text portions of this message have been removed]

[Non-text portions of this message have been removed]

Join to automatically receive all group messages.