I'd be interested in the answer to that question as well. When I play with mine. I have the same GREAT :( feature you have:) 73's Wayne Joyner K0BWJ - Omaha, NE

Hello! I�m a new user of the Kenwood TM-700D. On every band (A and B) I can select the different memorys. When I start the scanner on both bands, the scanner will stop on the same QRG in both

To save me and you a lot of time I get you to have a look at the mod site where I found it http://www.mods.dk/ I have yet to find out if it works and yes be careful !! btw : The only thing I have

Kiely, How do you get it into the service mode? And are there special precautions we should be aware of while it is in the service mode? Thanks, Karl, KG4BNA

I think I have found out how to adjust the deviation (well it adjust the figures and numbers) by going into the service mode then to the transmission deviation part then press and holding the Mic PTT

I have not. Hopefully someone else in the group has done this before. -philip [KG4FOZ]

Hi I have just got the Kenwood TM-D-700 and have been told that it has got low modulation I have TRY to adjusted it by the service mode but cant seem to move the deviation with < and > buttons all

Has anyone found a way to vary the delay before scan resumes after carrier drops? Thanks, Jerry VE3DKD

http://members1.chello.nl/~r.voerman/ Cu Robert Http: http: //members1.chello.nl/~r.voerman/ Email : r.voerman@... AX25 : pd0pvl@pi8apd Email : pd0pvl@...

The deadline is September 18th. Please send in your entries. =================================================================== ==== Kenwood D700 APRS(tm) Speech Message Contest

Can anyone advise me how fast the TM-D700 scans through the memory channels? Jim AA0FJ

I have done this with a GPS III+ and a different "home-brew" GPS unit. Seems to be working fine. I have run my D-700/D-7 and my laptop running SA and have not noticed any problems. Chris KB9LTH

Kan iemand mij wellicht helpen aan de handleidingvan de TMD700E en dan nog het liefst in het Nederlands ? Ik heb namelijk eenTMD700E gekocht bij de firma in Katwijk, echter zonder handleiding.

I've done this with a Garmin GPS 35, and it works fine. I have the gps wired to my D700, and a DB9 spliced off from that (or is the radio connector spliced from the DB9? Either way). I run a Topo

Go MENU, and look at the options for the VOICE.. There is a SPEAK ALL and SPEAK APRS ONLY options.. When someone sends you a message it SHOULD say the call sign of the sender.. Also, if the message

I have this idea that I might like to use my Garmin GPS III+ so that I can use it with both my D700 and very occasionally with a laptop running Map 'n' Go. The book with the GPS III+ indicates that

What do I have to set in the D700 to have the voice synthesizer read out the callsigns and messages in the aprs mode? It does speak the commands, but does not work with the aprs information. -

I visit this site and found Md700100.exe file i download it and it�s working fine. If you don�t could download it i send you by mail. Thank for your interesting. 73�s form EB4CPK

The software MD700100.exe is usually available via the Kenwood ftp site. (ftp.kenwood.net) The problem is that the site has been down today. This is the first time I have ever seen it down, but it

There was a post earlier about someone getting muddy audio when using cross-band repeat. I too am having this problem. Looks like a design flaw. -- has anyone found a solution or workaround for