(1) "Also" in Settings [APRS] {600} there is as mentioned by the guys here, "APRS LOCK : OFF (or ON) (2) If I press "F" briefly I get thee expected. However if I HOLD "F" for more than a second, I

There is also a lock function for the aprs setup, is the aprs12 symbol on ? Ray

I'm not near my radio but I think it it's tap [F] once then press [F] (1s) needs to be in function mode to unlock. Thanks, Eric K8ERS

My D710 appears locked. The panel shows it's locked and all the panel and mike buttons and knobs beep when pressed or turned. This implies two things; it's locked and all the buttons (including knob

Ah-ha! It won't do -0, but will do -1, -2, -3, ....I was wrong about that. All good now!

Oddly, if I do so with N4SRN alone it stores with Tuning Control knob press, but add a dash zer -0 or dash any digit fails to store. Hmmm.... Bret/N4SRN

FOR SALE: TM-D700A I've been using this mobile in my truck for several years. Works perfectly. I want to go with a digital mobile so I want to sell the KenWood. I have found the original Box! Still

When you complete the NN4SRN-0 entry into the Option 600 My Call Sign field, you must press the Tuning Control Knob (large knob on lower left of head unit) To place the completed call sign into

I'm stuck at the same point. I've entered my callsign in APRS but cannot figure out what to press to get it to save. rather than exit w/o saving. My blinking cursor is on the space after N4SRN-0.

HU Leo Thanks for this. I am still waiting for Kenwood to send me two of their connectors, supposedly arriving from Japan. It would be really good if a non-Kenwood source is found for spare

I was wrong, the connector pitch is 0.5mm. I got it wrong because half the pins (13) are on one side and the other 13 are on the other. And the spacing between the PCB pin pads is 1.00mm. I got the

Thanks Leo I will certainly post the results of my efforts. Hopefully it won't take the connector long to get here. 73 Joe VA3JLF

I can believe that. Kenwood TNC is a reasonably standalone module (this is why I am using itseparately) but it frequently communicates with the rest of the system via internal dedicated serial port.

Hi Leo I forgot to ask you. I have been told that the reason that my d700a will not boot up is because the tnc is not connected and that, once it is connected, all will be well. Do you have any

Hi Leo Thanks for this info. I was wondering actually why I was having so much trouble with a simple connector. Anyway, I have gone up and down this way and that and finally found from Kenwood US

From the service manual and internet pictures it looks like a 26 way vertical FFC connector with 1.00mm pitch. Have a look here

Joe, I have just recently (this week) bought a spare TNC from D700 for a project - to play with. It came with a ribbon cable. I forgot it in the office but I will have a look while I am there over

Hi In a previous recent post I have indicated that my radio is refusing to start evidently because it cannot recognize the tnc because of the broken ribbon cable connector. When I try to start, the

Hi Leo I don’t have a picture of the particular part because it was destroyed by the tech who was looking at it. But I can take a picture of the one that connects at tnc end. That one is a

Do you have a high resolution picture of this part? Leo