Hello, I have an older d-710a that I recently acquired. I am having trouble figuring out the group scan/ group link features. The manuals are less helpful than I need. Anyone have experience with

set Ch B to that QRG and 9600b but was running through AGWPE and figured that was wrong protocol. Or I set the Rig up incorrectly. I can ask over on AMSAT but thought there may be another D710 using

Yikes, Lynn ... it seems that this entire Email-List-Interface "mostly" doesn't send all emails to me. And I see nothing in "Junk/Spam" Yes, I have a D710GA ... didn't find, on my initial look, a

If you check the APRSISCE group, you should have received my response to your question about D710 in APRS mode not supporting digipeating from APRSIS32.  It's technically not possible in that radio

I am also using APRSIS32. However quite a while back I asked this and never heard from anyone over there. I have menu 616 Digipeat set "on" so here is a snip from the Digipeat log of

That feature came in with the TM-D710, the successor to the D-700. The frequency part of the APRS spec was not developed until well after the D700 was released. Sorry, but the TM-D700

The TM-D700 is supposed to have a feature where when someone enters the frequency they are monitoring and you press the tune hot key it is supposed to tune to that frequency on your listening band. I

I checked, radio is still on, and the call there is K7JCN-9. I had my mobile on 9 also so changed that. I look on APRS.FI and I do see my raw packets there from today up to yesterday and the day

I'll check the radio when I get home. I left it on I'm pretty sure. I'll let y'all know

I see a -2, -3 and -9, but no -7 The HF gateway almost makes me jealous.. :-) The local noise floor, even with the home power turned off, is so bad that HF is unusable. On 160-10 meters, I can hear

Sorry k7jcn-7 is the one in question.

It's still on. K7jcn-9.

I wasn't able to find any raw packets for K7JCN. According to aprs.fi and aprsdirect.com sites, raw packets are only stored for a day or two so I'm guessing your radio has been off for a couple of

My call sign is K7JCN. I appreciate your checking!

Chad, If you would post your callsign, I (and perhaps others on the group) could take a look at your area on APRS.FI or FIND-U to try to see what is going on. 73 Randy

Thank you for all the suggestions. 73, Doug, KA2WFT

https://www.pacparts.com/model.cfm?mfg=kenwood&model_id=TMD700A&action=list_part For a list of all Kenwood TM-D700 parts from this vendor. Lee Besing, N5NTG 210-771-7075 San Antonio TX

Gigaparts.com had the right fan for my TM-D700A radio when the original fan got crushed while under the driver's seat, but they don't have any D700 parts listed today. Many other posts say to simply

OK, thanks. That was kind of my plan, to just look for the right size 12V fan, but thought I'd ask in case someone had found a particular unit that they were satisfied with and would

I have replaced the fan in several of my radios as the do fail in time. I have always used any 12v fan I could buy at a Hamfest that was the correct dimensions to fit the bracket. Have had to splice