Re: TM-D710G TNC and VHF Winlink


Jess Haas
 

Its rather simple. You just need kenwoods serial cable hooked up to a computer. You can use a USB to serial adapter or if you want to get fancy a bluetooth to serial adapter. Then set the radio to TNC mode and run the Winlink software.

-Jess
K5LLI

On Sep 2, 2017 2:17 PM, "hamandrovers@... [TMD700A]" <TMD700A@...> wrote:
 

Ladies and Gents,


I would like to extend my use of Winlink from strictly HF/Winmor using an FT-857 to VHF using the D710G's built-in TNC.

Would anyone like to point me to a configuration table, drawings or procedures for initial setup of the D710G?

warmest regards,

Dennis Yard
N1TEN
San Diego, CA
ARES EC San Diego
CERT San Diego
Skywarn
San Diego Bloodbank



Join TMD700A@groups.io to automatically receive all group messages.