Happens to all of us. We think we have discovered a great product, only to find out it works under specific circumstances. My philosophy is if there are many different solutions to a problem, there is no magic bullet to solving that problem. Thank you for letting us know.

Al

 

From: SouthBendLathe@groups.io <SouthBendLathe@groups.io> On Behalf Of Jim V via groups.io
Sent: Friday, August 5, 2022 8:35 AM
To: southbendlathe@groups.io; SouthBendLathe@groups.io
Subject: Re: [SouthBendLathe] Majic Rust Removal Fluid......

 

Well, it turns out I'm full of BS!  My 'magic fluid' was on magic on the chuck!!  I tried some on a

trailer I rebuilding & the LW had very little effect on heavier old rust.  must've got lucy on the chuck!

 

Seems like the Good Stuf is either Evap-o-Rust or Crud Cutter unless ya wanno get wild & use acid

 

THANKS For Your Input!!  

 

On Wednesday, August 3, 2022 at 10:00:06 PM CDT, Jim V via groups.io <flajimak220@...> wrote:

 

 

I stumbled across this late this afternoon.  Can't believe it took nearly 7 decades of wrenching.
Using this product as it as intended for 50yrs or more.  And just FINALLY figured out what a Great
Rust remover it is!!!    The 'oil' was spilled on the chuck for about 30-45 minutes before I took a small, 
worn old wire bush to it.  Literally bushed for 2-3 minutes with the following results.  I'll have to do
more testing, but this appears to be the best rust remover I've found to date (that's date as in time,
not to go out with).   That is of various stuff found in the garage or shop not purchased specifically
to Remove Rust.

At the risk of being somewhat of an a--hole, i'll ask what you've used with similar results.
I'll divulged my secret tomorrow!