Note: groups.io will be down for maintenance on Monday, September 26th, starting at 9AM Pacific Time (4PM Monday September 26, 2022 UTC), for approximately one hour.
Hall Effect Tach on SB 9" - Solved
Thanks everyone for thoughts. I already had a choke similar to your picture, so I installed it 1" from the display. Problem solved! I did have to solder in some extra wire to wind it, but that was the only modification other than the choke. As my original post indicated, this was my suspicion, but your info helped a lot in doing it properly. Without that info, it is likely I would have done it wrong.toggle quoted messageShow quoted text
I will post some pictures now that I know it works in case anyone else would like to add a tach to their 9". It was a little tricky finding a spot to install it without physically altering the machine. I always try to avoid doing anything to old machines that can't be undone such as drilling holes.
On 6/23/2022 3:41 PM, Gary Johnson via groups.io wrote:
My experience is with the very nice MachTach unit, sadly no longer available. I'd agree that installing the strong, rare-earth magnets is helpful, and make sure they are close to the sensor when they pass. I expoxied 4 magnets on the face of the big gear in my heavy 10 to get 4 pulses/rev. Flawless operation.