it's alive!!!! - first run of a SB13B I am working on
|
Des
https://youtu.be/sNumbAgICXI still a lot of work to do, but it's actually turning now. A very big shout out to Steve Wells for the assist on the overhead countershaft speed figure. Des in Oz (Australia)
|
|
|
|
Thanks for showing this, good to see these old machines running.
toggle quoted messageShow quoted text
On Mar 22, 2020, at 6:42 PM, Des via Groups.Io <desbromilow@...> wrote:
|
|
|
|
Jim Schaffroth
I’m missing the top pulleys for my lathe. I am thinking of using one pulley on top and a treadmill motor. Is that a serpentine belt you used? Did you use a splicer?
On Sunday, March 22, 2020, 6:42:16 PM PDT, Des via Groups.Io <desbromilow@...> wrote:
https://youtu.be/sNumbAgICXI
still a lot of work to do, but it's actually turning now. A very big shout out to Steve Wells for the assist on the overhead countershaft speed figure. Des in Oz (Australia)
|
|
|
|
mike allen
my treadmill motor had a fan on the outboard side , so I
took off teh flywheel/cast pulley & made my own pulley from a
hunk of aluminum & then I marked the shaft where then set
screw lined up & ground a flat there fore the set screw to stop on . be careful if ya do pull the pulley , it's a left hand thread 1/2 x13 LH taps & dies are readily available & their pretty cheap . what are ya gonna use for a speed controller?
animal
On 3/23/2020 5:37 PM, Jim Schaffroth
via Groups.Io wrote:
|
|
|
|
Jim Schaffroth
I have the one that came with the treadmill. I put a 10k potentiometer on it
On Monday, March 23, 2020, 5:57:02 PM PDT, mike allen <animal@...> wrote:
my treadmill motor had a fan on the outboard side , so I
took off teh flywheel/cast pulley & made my own pulley from a
hunk of aluminum & then I marked the shaft where then set
screw lined up & ground a flat there fore the set screw to stop on . be careful if ya do pull the pulley , it's a left hand thread 1/2 x13 LH taps & dies are readily available & their pretty cheap . what are ya gonna use for a speed controller?
animal On 3/23/2020 5:37 PM, Jim Schaffroth
via Groups.Io wrote:
I’m missing the top pulleys for my lathe. I am thinking of
using one pulley on top and a treadmill motor. Is that a
serpentine belt you used? Did you use a splicer?
On Sunday, March 22, 2020, 6:42:16 PM PDT, Des via
Groups.Io <desbromilow@...> wrote:
https://youtu.be/sNumbAgICXI
still a lot of work to do, but it's actually turning now. A very big shout out to Steve Wells for the assist on the overhead countershaft speed figure. Des in Oz (Australia)
|
|
|