Yes, that's 1144 not 1177...brain fart. SW

Hi Bud, Right now I'm just trying to get these ready for the workshops. What size and pitch is your 13" screw? I'm sure someone is reading this that can help you with that, I think it's the same old f

Ok Bill, Send me you mailing address in private e-mail and I'll get you one out. wswells@... Steve

No Rich, the screws are the same length on the large dial as the small dial. The difference is in the handle blank length and the the length of the gear blank. See the attached photos if you are recei

John, just e-mail your shipping address to me and I'll send you one. I'm going to wait untill I get all ten requests, then I'll mail them all out at once. There are 6 screws remaining. Steve

Sorry, John I'm getting sleepy. e-mail: wswells@... Steve

Sorry Guys about the blank sends, my mouse is sticking. George, I didn't turn them, I had these thread rolled to my specs. I've been waiting about 3 1/2 months on them to arrive. I have about 168 feet

Thanks John, I'll send you one out. Steve John S. Phillips wrote:

Rick, Send me you shipping address by e-mail. yes, same as 10K. Steve wswells@... tuffree wrote:

OK guys, I have about 25 names and that's about all I can do right now. I'll try to get them all ready over the weekend, should go out the first of the week. I appreciate your help in evaluating the p

Tom, Beautiful, detailed and very clean, I am impressed. These are the first pictures of it back together I have seen. Would you send me a few more that I could use on my website? And....you used the

Jack, Your lathe is a 1947, and yes a catalog model 444, would have the code designation NAR in the serial number, that would be a 9" model A 6 speed horizontal motor drive(HMD) bench lathe. I'm not s

The Y is a 3 foot bed, and back to the 8, I think that was a revision change number. Steve

Jack, I may have spoken to soon, now it could be a 1948. I don't have enough numbers in my serial number file to say for sure. Why don't you call Leblond and find out? They will give you the line card

Steve A. Ditto on Denny's, only I used a heavy ten drive, made the lower mounts, took off all the adjusters, added a shorter serpentine belt, and adapted a 9" over center tensioner to the 10L switch a

Can you tell me what these fit? Steve

Har Har ...I don't need them, if someone can ID them they are setting on the shelf collecting dust. Hey, did you get the Dalton screws I sent monday? Sw

I've uploaded the July 1942 100-B full catalog that fellow member, Bud B. sent to me. I'm caught up from sending out test feed screws, got the head gaskets replaced on the "Ugly" orange mower. Now it'