Hello John, Thank you for the response. I was suspecting a thermal issue based on what I've seen. Your message confirms that may be possible. I have been unable to find a part number or any

Francis Tuttle Technology Center in Oklahoma City. North-West side of town. South-West side of town has Moore-Norman Technology Center. The precision manual machining class cost $1800 last last I

Hi, contactor on the left, has an overload unit below, this acts as an adjustable fuse, can it be set, a shade higher, ?? Regards jb

I keep a gallon of diesel , some paint thinner, and a gallon of Evaporust around the shop to clean my lathes and mills - load the diesel a quart at time in a laundry room plastic spray bottle. Squirt

On my South Bend 10k the power will randomly shut down and a reset is needed to restore power. I'm looking for ideas on what might be causing this. Current consumption is 4.6 Amps while turning and

Cast iron gets used for high precision surface plates. In 2014 a huge one made by Gorton for use in their factory was sold on eBay. According to the data plate on it, it took seven years from casting

Bolt the headstock end down snug then check to see which side of the tailstock end foot is not touching the benchtop. Put shims under that side. Making sure the bed isn't twisted is easiest if it's

Johnny, Do not worry about having taper in your piston. Real pistons are tapered and are barrel shaped. They DO NOT have a true cylindical shape. Generally, the bottom of the piston has the largest

https://mansfield.craigslist.org/tls/6009312657.html These items fit USPS flat rate boxes....

Another suggestion if you have some time... Search Craigslist ( Both local and around the country ) for a machinist who is retiring. They usually have excellent equipment and have taken great care

Nice bench! It looks very sturdy. The one leg under the "tail" seems somewhat unique. The vertical space for the chip tray seems generous. Thanks for sharing, Don

Interesting method. Ed, Thanks for sharing! - Don

I have used this tool post in trade school and two shops I worked at later on and there is non finer. One of variations in the Engineering shop had an indexing which was incredibly repeatable. I now

Agreed re the price - was this a 'one-of' or can you name the source as I would be interested too, M

A ha Thank You Alec

They are expensive in The

AXA-AA is a smaler one then the AXA-A. http://www.multifix.eu/de/ From smal to large: AXA-AA AXA-A AXA-E AXA-B AXA-C AXA-D1 AXA-D2

Price:200.00USD Standard set:1 set including 5 pieces 1 x Aa toolpost,3 x AaD1250,1 x AaH1250 Click "MORE" to visit Technic Data and Parameter.

http://www.machinehandelbos.nl/aanbod-toebehoren/snelwisselsystemen

A Euro is 1.06 us dollars today. If you pay 425 Euros that is 450.5 us dollars that's way to much.I do a lot of machining i would not buy it even if i would still run a machine shop full time GP