Re: heavy 10 thrust bearing PT2O7R1
|
Jasper McConnell
Thanks Greg. If I had thought of that I wouldn't be so red faced now. Since it will be done in one setup,it will probably be very parallel on the faces.
toggle quoted messageShow quoted text
I wasn't considering putting my lathe back together before I resolved the problems. Suppose it won't be any worse off than it was for such a short job. Jasper
-----Original Message----- From: Gregg Eshelman g_alan_e@... [SOUTHBENDLATHE] To: SOUTHBENDLATHE Sent: Fri, May 8, 2015 12:33 am Subject: Re: [SOUTHBENDLATHE] Re: heavy 10 thrust bearing PT2O7R1 On 5/7/2015 9:10 AM, hotrodjap@... [SOUTHBENDLATHE] wrote:
> The radial needle > bearing require more than two washers to even come close to the setpoint > of the spindle location to OEM specs. You have a lathe so make spacer rings of the thickness you need to fill up the space after the pair of hardened washers and radial bearing are in place. --- This email has been checked for viruses by Avast antivirus software. http://www.avast.com
|
|
|