Re: 14-1/2 spindle nose and taper


I have not but would say that is your call.  You can also ream the finish internal taper using a Morse Taper finish taper in the tail stock.   I would only do this turning the spindle by hand not under power. 

Conciser making MT1- MT2- MT3 adapters and a blank or two while you are setup?

On Wednesday, June 1, 2022, 11:50:18 AM CDT, Rangelov <rangelov@...> wrote:

That will make it easier to hold and keep it true.

Should mark spindle and adapter in case the adapter is removed and reinstalled.  Probably unnecessary since is probably true. But why not?

Join to automatically receive all group messages.