Re: SB9c rebuild - Reversing Bracket


Glen Ruch
 

I would go with page 3 of this parts manual . . .

Regards.

On 6/9/21 11:58 PM, david pennington via groups.io wrote:
Greg,

This pic is from the 1966 edition of the SB manual. The lathe appears to be a Model 9C. The value may be the labels on the pic.

Dave

-------- Original message --------
From: "G K via groups.io" <bug_hunter2000@...>
Date: 6/9/21 20:06 (GMT-07:00)
Subject: Re: [SouthBendLathe] SB9c rebuild - Reversing Bracket

Dave,

Thanks for the pic. Any chance you can verify the tooth count on the outer gear. I’m guessing it’s a 16-tooth.

Thanks,

Greg




On Wednesday, June 9, 2021, 8:39 PM, david pennington via groups.io <davidwpennington@...> wrote:


-------- Original message --------
From: "G K via groups.io" <bug_hunter2000@...>
Date: 6/9/21 19:07 (GMT-07:00)
Subject: Re: [SouthBendLathe] SB9c rebuild - Reversing Bracket

Hey Guys,

Need someone to take a look at their 9c, or enlighten me a bit.  I am assembling the reversing assembly, and there there is a reverse gear, as well as a similar sized smooth collar or spacer that appears to go onto the reversing shaft.  Not sure of the order, collar near the bracket, or gear near the bracket.  Also, I have seen photos of a reversing assembly where there are two gears instead of a gear and a collar.

Photos, directions, Insight?

Thanks,

Greg

 

 

Join SouthBendLathe@groups.io to automatically receive all group messages.