Re: Lathe horizontal drive motor and pulleys


john kling
 

The manufacture's decision to have a v belt run (on one side) on a large flat  pulley is counter intuitive. Several other manufactures also used this set up. When i noticed that a new to me SB had this set up. I assumed it was a previous owners set up/ mistake. Perhaps a large v pulley  was expansion or increases friction from the side of the belt.

On Thursday, December 10, 2020, 11:34:37 AM EST, E A <b-arch@...> wrote:


Now if I could only find one of those flat countershaft pulleys, I'd be in like Flynn.
Erik A


From: SouthBendLathe@groups.io <SouthBendLathe@groups.io> on behalf of comstock_friend <jfriend314@...>
Sent: Wednesday, December 9, 2020 10:55 PM
To: SouthBendLathe@groups.io <SouthBendLathe@groups.io>
Subject: Re: [SouthBendLathe] Lathe horizontal drive motor and pulleys
 
Here are the South Bend Forms for the belts and pulleys, and the horizontal and underdrive for 9" and 10K lathes. Also the speed chard from my HTRAL.

Note that while the motor pulleys are V-pulleys, the countershaft is flat. The V-Belt runs on it perfectly.

John

Join SouthBendLathe@groups.io to automatically receive all group messages.